campblasterBuilding instruction

F a b l a b N o r d v e s t

We would like to give A special thanks to

for the powerbanks to power up the campblaster

for the laser cuttet parts to the campblaster

The tools

Soldering iron wood glue masking tapescrewdriverSoldering wire

The parts

Power print board USB print board

Powerbank

Insulation

screws

glue here

watch movie: How to assemble the cabinet

watch movie: Put masking tape on the cabinet

Solder the red wire to 1 and 2 solder the black wire parallel to pin

10 and 9

solder the red wire to + solder the black wire to -

check that the campblaster says:

the campblaster is on - with a sligtly russian accent

and then disconnect the parts

mount the usb socket on the back of the

back piece

and mount it with medium sized screws

mount the print board underneath the

usb socket

place the acylic rings so they fit two

of the holes in the print board

please be careful while screwing

- gently

put the acrylic rings on

use the screwdriver to mount the

printboard

insert the power wire into the red switch

insert the speaker use the golden screws to mount the

speaker

put insulation into the speaker place it good

Remember to drag the speaker wire up

insert the speaker wire into the white

switch

Check if the speaker works

before mounting the back piece

watch movie: how to mount the back piece

watch movie: Put masking tape on the back

place the spacers on the front place the acryllic piece on the front

use the longest silver screws to mount

the acryllic front pieceNow the campblaster is on!