c r e ati ve fa b r ica · cover2\2 folder (281) (928) (3066) (3344) (7751) stop 1 stop 2 stop 3...
TRANSCRIPT
Creative Fabrica
© Creative Fabrica
Embroidery DesignSewing Information
www.creativefabrica.com/embroidery/
Passport cover
Stages of work in video https://youtu.be/rTlaBhlBYBQ
https://www.youtube.com/watch?v=3OLuvRjLeLs
1. Set up hoop with heavy tear away stabilizer.
2. Fabric placement stitch.
3. Cut fabric to size, to go over placement stitch.
4.Fabric placement - Place fabric over outline.
5. Start your design.
6. Cut 2 squares (size 20*20 cm) and 1 rectangle (size 20*30 cm)
7. fold the square in half and press with an iron.
8. Place 2nd piece of fabric right side up on the bottom of the hoop to cover stitching.
9. Stitch in place.
10. Mark the fabric with the required measurements. (6-8 cm)
11. Place your pocket pieces of fabric right side up to the back of hoop, as shown.
12. Finishing Stitch.
13. Trim fabric as close to stitching as possible.
14. Finish off the remaining stitching, then remove from hoop. Burn off the loose threads very carefully.
15. Your finished embroidered passport cover .
I hope you enjoyed working with my embroidery design.
Thanks for buying