IPC.2338/REV.2

FIG. 1

FIG. 2

1. Determine the location of the toiletry shelf on the wall.

Note: • Avoid locating where a stud may interfere.

2. Transfer the template (12x18 Toiletry Shelf TemplateIPC.2339) to the wall. See Figure 1.

3. Drill a 3/8" hole at each corner of the template. Using ajigsaw, cut along the template to form a hole in the wall.See Figure 2.

4. Dry fit the toiletry shelf in the opening. Ensure that the larger compartment is on the top. Using a level align the toiletry shelf and add guide lines to the wall. See Figure 3.

5. Apply beads of silicone adhesive to back flange of the toiletry shelf, leaving room for hot melt glue.See Figure 4.

BioPrism® Solid Surface Installation Instructions 12x18 Toiletry Shelf

FIG. 3

Please read all instructions before installing products.

11 1/8”

17 1/8”12x18TOILETRY SHELF TEMPLATEIPC.2339

FIG. 4

SILICONEADHESIVE

STUD

STUD

5. Apply hot melt glue to several locations on the back of the toiletry shelf. See Figure 5.

6. Immediately position the shelf in the opening, making sure that the shelf is level. Remove any excess adhesive with denatured alcohol. Tape the toiletry shelf to the wall, to hold in place until the adhesive cures. See Figure 6.

7. Allow silicone to cure before removing the tape. Complete the installation with a bead of silicone around the perimeter of the toiletry shelf, where it meets the wall. Clean-up excess silicone with denatured alcohol. See Figure 7.

FIG. 5

BioPrism® Solid Surface Installation Instructions 12x18 Toiletry Shelf

FIG. 6

FIG. 7

DROPS OFHOT MELT

GLUE

SILICONE SEALANT