bevel gear assembly - bharat heavy electricals limited · 1.name of component -bevel gear assembly...
TRANSCRIPT
-
1.NAME OF COMPONENT -BEVEL GEAR ASSEMBLY
2.BOM . NO.- V13824
3.MATERIAL –
a) Housing: Aluminum alloy chilled casting
weight 3.2 Kg
b) BEVEL GEAR –CARBON STEEL FORGING CLASS-IV NORMALISED
WEIGHT -0.84 Kg
-
c) DRIVING SHAFT
material :sTAINLESS STEEL BAR
HEAT TREATMENT : The recommended heat treatment is as follows: Harden in oil / air at temperature of 950-1050°C. Temper at suitable temperature between 650-750°C. Details of the actual heat treatment cycle followed shall be specified in the test certificate
Tensile and impact: The test pieces shall show the following properties: Ruling section, Tensile Yield Percent I mpact Strength mm strength, strength,min Elongation,min at Room N/mm2 N/mm2 Temperature, ISO-V, Joules Upto160mm 700-800 500 13 25 (Inclusive)