basic geologic principles *
DESCRIPTION
Basic Geologic Principles *. Principle of Superposition Principle of Original Horizontality Principle of Lateral Continuity Principle of Crosscutting Relationships (*Notes). Principle of Superposition * Younger sedimentary and volcanic rocks are deposited on top of older rocks. - PowerPoint PPT PresentationTRANSCRIPT
Basic Geologic Principles*
Principle of Superposition
Principle of Original Horizontality
Principle of Lateral Continuity
Principle of Crosscutting Relationships
(*Notes)
QuickTime™ and aTIFF (Uncompressed) decompressor
are needed to see this picture.
Principle of Superposition*
Younger sedimentary and volcanic rocks are deposited on top of older rocks.
The principle of superposition states that in an undisturbed layer of rock, the oldest rocks are on the bottom and the rocks become progressively younger towards the top.
Exception: overturned rock layers due to folding.(*Notes)
Principle of Superposition*
Relative Dating
Relative dating is used in geology to determine the order of events and the relative age of rocks by examining their position in a sequence.(*Notes)
Principle of Superposition
OLDEROLDER
YOUNGERYOUNGER
270 Million Years Old
600+ Million Years Old
TIMING: RELATIVE vs. ABSOLUTETIMING: RELATIVE vs. ABSOLUTE
Geologic Time
http://www.classzone.com/books/earth_science/terc/content/investigations/es2903/es2903page03.cfm?chapter_no=investigation
Principle of Original Horizontality*
Sedimentary and volcanic rocks are laid down in approximately horizontal layers.
This principle is important in the analysis of folded and tilted strata.(*Notes)
Originally Horizontal
Layers on top of layers
Folding & Tilting
QuickTime™ and aTIFF (Uncompressed) decompressor
are needed to see this picture.
The Flatirons Boulder, CO
Folding & Tilting
The Atlas Mountain system of northwest Africa
http://www.classzone.com/books/earth_science/terc/content/investigations/es2903/es2903page04.cfm
http://www.classzone.com/books/earth_science/terc/content/investigations/es2903/es2903page05.cfm?chapter_no=investigation
Folding & Tilting
Principle of Lateral Continuity*
Sedimentary and volcanic rocks are laid down in layers that are usually much greater in lateral extent than in thickness. -Layers of sediment initially extend laterally in all directions (laterally continuous). -Rocks that are otherwise similar, but are now separated by a valley or other erosion feature, can be assumed to be originally continuous.(*Notes)
QuickTime™ and aTIFF (Uncompressed) decompressor
are needed to see this picture.
Principle of Lateral Continuity
QuickTime™ and aTIFF (Uncompressed) decompressor
are needed to see this picture.
Principle of Lateral Continuity
QuickTime™ and aTIFF (Uncompressed) decompressor
are needed to see this picture.
Principle of Crosscutting Relationships*
If a rock unit or geologic feature cuts across another rock unit or geologic feature, it was formed later in geologic time.
The principle of cross-cutting relationships states that a rock or fault is younger than any rock (or fault) through which it cuts.(*Notes)
Principle of Crosscutting Relationships
In a series of horizontal sedimentary beds, there is an igneous dike which cuts vertically through them. The dike is younger than the sediment beds though which it crosses, as the beds would have had to be around before the dike could have intruded.
QuickTime™ and aTIFF (Uncompressed) decompressor
are needed to see this picture.
Principle of Crosscutting Relationships
QuickTime™ and aTIFF (Uncompressed) decompressor
are needed to see this picture.
Cross CuttingGrand Canyon, Arizona
Cross Cutting
MOST RECENT
Unconformity*
A layer of rock is a record of past events. But most rock records are incomplete- there are layers missing. These gaps are called unconformities.
Unconformities develop when agents of erosion remove existing rock layers.
They also form when a period of time passes without any new deposition occurring to form new layers of rock.(*Notes)
Unconformity Unconformities Animation
In Figure 2, there are 8 different rock layers seen in this exposure. Layers 1-3 are horizontal while layers 4-8 are tilted. The contact between the horizontal layers and the lower tilted layers indicates an unconformity where the lower, older layers got tilted, then eroded down to a horizontal surface, followed by deposition of layers 1-3. Processes such a faulting, perhaps associated with mountain building, can create this kind of tilting and unconformity on Earth.
QuickTime™ and aTIFF (Uncompressed) decompressor
are needed to see this picture.
Unconformity Unconformities Animation II
Unconformity
QuickTime™ and aTIFF (Uncompressed) decompressor
are needed to see this picture.
Unconformity
Unconformity
Olympic Coast, Washington: 4th Beach near Kalaloch
Basic Geologic Principles