band saw safety pre-test. you should not support the stock with your hands on each side of the blade...
TRANSCRIPT
You should not support the stock with your hands on each side of the blade as a cut is
being made.
FALSE – support the stock on each side whenever possible
If you back out of a curve, leave the saw running as it will decrease the friction and
allow the blade to easily slide out.
FALSE – turn off the saw, wait for the blade to stop
The teeth on the band saw’s blade move up and away from the stock as it is supported on
the table.
FALSE – the teeth move down towards the table
Adjustments on the band saw can be made while the machine is coasting.
FALSE – the machine should be at a complete stop
Your sawing procedure should be planned so that you have a minimum number of backing
out of cuts.
TRUE
It is acceptable to leave the machine while it is coasting to a stop as long as the power has
been shut off.
FALSE – wait until the saw is completely stopped
It is acceptable to use the miter gauge for cutting several pieces of wood at the same
time to the same length.
FALSE – cut one piece at a time
It is acceptable for the blade to run near the outside edge of the wheels as long as the
tension is properly adjusted.
FALSE – the blade should run on the center of the wheels
Safety glasses should be worn only when the saw is turned on.
FALSE – safety glasses should be worn at all times
When making sharp curve cuts, use ________ to keep the blade from becoming twisted in the cut.
relief cuts
If you have to get close to the saw blade while the machine is running, a _____________
should always be used.
push stick