Fitting for modelTC-830 TC-800

1 2 3 4

Antistatic cape

ON/OFF Switch

Baby hair clipper How to trim the hair with the barber comb

1.take off the guide comb firstly 2.using the barber comb or finger to lift the hair ( as pic. shows)3.left the unwanted hair above the barber comb or finger4.comb the hair in time, to clean up the unwanted hair

Warn! be care of the sharp blade! it will probably hurt the people when trim round the ear .Avoiding any accident, please be care of the cutting edge, and avoid to touch the ear . Or you can cover the ear by hand .

Method of Cleaning

Method of fixing /taking off the guide comb

there are two slots on both side of the "head part",posit the comb in the right place, and push it until you hear the "click" sound ( please make sure the guide comb will not loose or drop off )

Method of fixing the guide comb

push out two "ear " of the guide comb( please do not push the "comb " part , it will damage the comb )

Method of taking off the guide comb

Specification

profuct name : professional pet hair trimmer

model no.: TC-830 TC-800

Adapter: Input: AC 100-240V 50-60 HZ Output: DC 5.0V

battery capacity : 3.7v 650mAH

battery type: lithium battery

charging time: 1 hours

operating time : about 120minutes

how to operate the hair clipper with the adapter plugged

Method of charging

Method of charging

1. put the cord into the charging pin of the hair clipper 2. make sure the switch is in the OFF positon, then get the adapter plugged3. the charging indicating light will start to glitter with red light, when it turns to green, the machine is fully charged4. Unplug the cord , and turn on the switch for operation

Notice of charging

1. 5℃-40℃is the best temperature for charging 2. charging time is about 1 hour 3. only when there is no or few battery ,the battery need to be charged

please make sure the hair clipper is fully charged for your first time use

this product is only used for cutting the hair ,other usage is not allowed cutting the colored or wet hair is not allowed

how to operate the hair clipper with the adapter plugged

1. put the charging pin into the hair clipper 2. make sure the switch is in the OFF position, and make the adapter plugged 3. turn on the hair clipper and start to use

Name of Accessory

blade

main body

ON/OFF Switch adapter

charging indicating light

cord

Accesory

Guide comb 3/6mm

Guide comb 9/12mm

Cleaning brush Oil bottle

Push the blade out of the hair clipper with your thumb ( as picture shows) Push the blade bridge , make some space between the cutting blade and comb blade, and clean up all the hair there with the brush. ( please never disassemble the spring out of the blade. it might cause the malfunction)After cleaning,drop 2 or 3 oil on the blade,and put the blade back to the hair clipper(please make sure,you hear the "Click"sound,it means the blade is fixed back successfully)

Attention

it is common that the machine getting warm when the battery is under charging

Product Name

Model No

Manufacture No

Purchase Date

Baby Hair Clipper

TC-830 TC-800

Date Month Year

Guarantee Time

terminal time : Day Month Year

Customer

One year from purchase date

seller

Address

Address

ProductName

Name

Phone No

Name

Phone No

Guarantee

1. This products is strictly tested and inspected by QC in the factory 2. Malfuction caused by regular use can be guaranteed for 1 year free servicein our shop /store /fixing center (please note : battery only has 6 months guarantee, and the blade is not fitting for this service also ) 3. Among the guarantee time, the following situation need to be charged a) malfunction caused by faulty operation b) malfuncion caused by personal aimed repair or recreation c) malfuncion caused by some natual disaster d) damage or malfunction caused by drop off e) malfuncion caused by local Power f) malfuncion caused by wrong operation without checking this manual4. please show your invoice and guarantee card if you need to repair the product 5. All accessories for repair use will be kept for 3 years

*

* the Lithium battery is sealed inside of the hair clipper , before you throw away the hair clipper, please take out the battery , and store it /them in an environmental place. Manual

How to cut the hair with the guide comb

1. if this is your first time to use this hair clipper, you better to choose the 12mm guide comb, and cut few hair each time. when you're good at it , you can choose other size guide comb for some shorter cutting . 2. hold the hair clipper with the blade facing you ,making the guide comb touch the head skin, and cut slowly and steadly. (pic.1) 3. cut the hair back of the head, need to lower down your head , and use the guide comb 3mm or 6mm or 9mm, start from the center to other suround parts (pic.2) 4.for two side of the head, use the guide comb 3mm or 6mm or 9mm,and cut the hair above or round the ear as the picture shows.

1. please do not disassemble this machine without any professional guidance 2. please keep this machine away from the wet or moisture place

3. please do not clean the machine with gas,alcohol,but some dry fabric can be ok

4. please do not charge the machine lower the 0℃ or higher then 40℃

OIL

Aic

oh

ol

To

lue

ne