autoignition in turbulent flows christos nicolaos markides and epaminondas mastorakos aiming to...
Post on 22-Dec-2015
216 views
TRANSCRIPT
Autoignition in Turbulent FlowsChristos Nicolaos Markides and Epaminondas Mastorakos
• Aiming to accurately predict and control the occurrence of the phenomenon of autoignition in a turbulent flow field we:– Have undertaken an experimental and theoretical investigation in order to understand the fundamental underlying physics of the
coupling between turbulent mixing and the chemistry of autoignition down to the smallest relevant length and time scales– Are investigating the topological manifestation of autoignition and the dependencies of its genesis
• We choose a co-flow configuration which:– Is a novel approach for the demonstration of autoignition phenomena– Is very appropriate for the investigation of mixing effects– Allows precise and accurate characterization of the background turbulence (fluid-mechanical character) and mixture fraction
(chemical character) fields– Provides direct measurements of autoignition length and associated time, which are quantities that have direct and intuitive
practical meaning and significance
Goals
Experimental Configuration Typical High Speed Sequences(the relative micro-lengths and micro-times of autoignition)
Typical Results
-210
-110
010
+110
+210
-31010+210+1 10+3 10+4 10+5
Frequency (Hz)
+0.5
5
0
10
15
20
0-0.5-1.0 +1.0
0.4
0.3
0.2
0.1
0-1.0 -0.5 0 +0.5 +1.0
2.0
1.0
0-1.0 -0.5 0 +0.5 +1.0
1.8
1.6
1.4
1.2
0.8
0.6
0.4
0.2
Cold and Hot Flow Characterization
Hydrogen
Many individual snapshots of hydrogen autoignition spots (below left), are used to compile PDFs of the autoignition location (below right). Autoignition lengths can be defined at the earliest location or in terms of the integral (mean) of the PDF and autoignition times by residence calculations based on the fuel jet velocity decay in the centreline of the co-flowing air. Typical Hydrogen results are shown on the far right. The effect of the jet velocity is successfully collapsed for each background air velocity. oo
Many individual snapshots of acetylene autoignition spots (left), are used to define an ‘earliest’ autoignition location. Typical global results for Acetylene are shown on the far right. As far as the location of autoignition is concerned, for a given air velocity and temperature, autoignition is always delayed by an increased jet velocity. This delay may be augmented by decreasing the temperature and/or increasing the velocity of the air. ooooooooo
AcetyleneMean Temperature and Velocity Profiles
Mean Velocity and Turbulence IntensityProfiles at various Re Numbers, Stream-wise
Locations and Injection Velocities
Fine Scale Turbulence Measurements includingIntegral Length Scale Profiles and Power Spectra
Mean Mixture Fraction Profiles andCorrelation with corresponding Autoignition PDFs
Earliest Autoignition Length Vs. Jet Velocity
0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1.00
5
10
15
20
25
30
35
FLASHBACK
NOTHING
STABLESPOTTINGREGIME
Kinematic Similarity (Injection to Co-flow) Velocity Ratio
Each colour represents data for a particular air velocity and dashed lines are for higher air supply temperatures. Lengths in mm.
Injector
Fuel/Nitrogen Mixtureat Ambient Conditions
Hot Air from HeatersHot Air from Heaters
Mechanism
Air MixerFuel Dissociation
Grid Turbulence
Insulation
Injection Location
Quartz Pipe
Spot
and Sealant
Autoignition
Injector Alignment
Generator
Quartz Sheath
LignDouble flame front spot propagation. Close-up at 40.5 kHz.
Injector
Acetylene ignition spot initiation, double flame front propagation and ‘stabilization’ (no advection). Then,
triple flame structure formation and flashback (upstream advection) to form a flame. Real time at 13.5 kHz.
Injector
0.70
0.75
0.80
0.85
0.90
0.95
1.00
-0.1 0.0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1.0
r/Rinner
T/Tair
-0.1 0.0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1.0o
1.00o
0.95o
0.90o
0.85o
0.80o
0.75o
0.70
0.0
0.2
0.4
0.6
0.8
1.0
1.2
1.4
-0.1 0.0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1.0
r/Rinner
U/Ubulk
-0.1 0.0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1.0o
1.4o
1.2o
1.0o
0.8o
0.6o
0.4o
0.2o
0.0
Hydrogen Autoignition
0.1
1
10
1.04 1.05 1.06 1.07 1.08 1.091000/T
Me
an
Ig
nit
ion
Tim
e (
ms
)
Increasing co-flow air velocity. Each trend-line contains data for various jet velocities but a single air velocity.