Asus Transformer T100 Power ButtonReplacement

Replace the power button on the back casing.

Written By: Taylor Pantiga

Asus Transformer T100 Power Button Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 5

INTRODUCTION

The power button is known to occasionally get stuck behind the plastic backing of the T100. Thisguide will show how to replace this step by step.

TOOLS:Flathead Screwdriver (1)

Asus Transformer T100 Power Button Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 5

Step 1 — Rear Cover

Separate the tablet from the base by pressing the large silver button below the tablet.

Remove the tablet.

Step 2

Insert the plastic opening tool into the seam of the tablet casing and gently pry upwards.

With a little force, you will feel the clips release.

Asus Transformer T100 Power Button Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 5

Step 3

Slide the tool along all four edges ofthe tablet, making sure that all theclips are released.

Do not break these clips; otherwise,the screen will become less secure.

Step 4

Remove the rear casing.

Asus Transformer T100 Power Button Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 5

To reassemble your device, follow these instructions in reverse order.

Use a small amount of epoxy or other adhesive to attach the new button.

This document was last generated on 2017-09-30 06:52:16 AM.

Step 5 — Power Button

Using a flathead screwdriver, pry the button connection up.

There will be some resistance. Slowly increase the pressure until the button pops off.

Asus Transformer T100 Power Button Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 5