assembly instructions - tuft & needle...assembly for full, queen, king, and cal king 1 2 (note:...
TRANSCRIPT
Metal Base
ASSEMBLY INSTRUCTIONS
The diagrams and instructions in this brochure are for illustration purposes only and are not meant to replace a licensed professional. Any construction or use of the product must be in accordance with all local zoning and/or building codes. The consumer assumes all risks and liability associated with the construction or use of this product. The consumer or contractor should take all necessary steps to ensure the safety of everyone involved in the project, including, but not limited to, wearing the appropriate safety equipment. 8910TN 8/17
2-PERSON ASSEMBLY RECOMMENDED
IN THE BOX
Parts for Twin and Twin XL
If any hardware appears to be missing, or further assembly direction is needed, reach us at (877) 842-2586 or [email protected]
x1 A x1 B
x1 D x6 Fx6 Ex2 C
x1 A x1 B
x2 E x2 F
x9 Hx9 G
x1 D
x1 C
Parts for Full, Queen, King, and Cal King
B
C
D
C
A
Extend A and B fully as shown below.
Place C and D pieces with A and B. Line up all of the holes.
ASSEMBLY FOR TWIN AND TWIN XL
1
2
(Note: Frame is assembled upside-down.)
Tightly screw the support legs through every hole3
EE
F F
Flip the base over and adjust as needed.4
B
E
C
E
F
D
F
A
Extend A and B fully as shown below.
Place E and F pieces with C and D. Line up with A and B holes.
ASSEMBLY FOR FULL, QUEEN, KING, AND CAL KING
1
2
(Note: Frame is assembled upside-down.)
Tightly screw the support legs through every hole3
G
H
Flip the base over and adjust as needed.4
Keep These InstructionsRetain these assembly instructions for future use
5-YEAR WARRANTY 100-NIGHT TRIAL
For information about this product’s 5-Year warranty and 100-Night Trial, visit:tuftandneedle.com/legal/warranty
Questions? We Have Your Back.Call (877) 842-2586 or email us at [email protected]
