application notes - pj evans & co...fibretech primer coat 0.4kg/m² 225g chopped strand mat...
TRANSCRIPT
Application Notes
Aquaguard Pool Resurfacing System
(Instruct ions for use of Aquaguard pool resurfacing system on concrete sw imming pools and f ibreglass pools)
1. a Acid w ash new rendered concrete w ith 20:1 HCI or
b Sand blast painted surfaces or
c Acid w ash marblesheen w ith 5:1 HCI
2. When dry, prime w ith Fibretech Primer Coat using Nuplex SR Catalyst at a rat io of 2%.
3. Laminate w ith 225g CSM and Fibretech Laminate Coat using Nuplex SR Catalyst at a rat io of 1.5%
4. Once laminate has cured, sand off sharp f ibres and repair any air bubbles.
5. Apply Fibretech Fillcoat using Nuplex SR Catalyst at a rat io of minimum 1.5% by w eight (low temperature
eg 15° C use 2%). Apply w ith long nap applicat ion roller.
6. Allow to cure (minimum tw o hours). Sand off any defects.
7. Only apply Aquaguard Topcoat out of direct sunlight (either late afternoon or preferably early morning).
Use a minimum of 1.5% Nuplex NR20 Catalyst. Keep a w et edge at all t imes. Use a long nap applicat ion
roller.
8. Never apply to damp or dust coated surface.
9. Approximate material usage per m² of pool:
Fibretech Primer Coat 0.4kg/m²
225g Chopped Strand Mat 0.25kg/m²
Fibretech Laminate Resin 0.8kg/m²
Fibretech Fillcoat 0.6kg/m²
Aquaguard topcoat 0.6kg/m²
10 To use on exist ing Fibreglass pools w ithout osmosis, sand the ent ire surface, t ile around the w aterline and
complete steps 5 onw ards.
11 Allow topcoat to cure for a minimum of 4 days before ref illing the pool.
Note: Longer cure times will be required during the cooler months and at no stage during the curing cycle
should the topcoat be exposed to wet weather.