an/upr-4(v) - telephonics...an/upr-4(v) is a receive-only system that does not interfere with...

2
As a benchmark innovator of Identification Friend or Foe (IFF) interrogators, Telephonics is offering its AN/UPR-4(V) Passive Detection and Reporting System (AN/UPR-4(V)). Designed in a small, yet rugged package, the AN/UPR-4(V) meets the military’s situational awareness requirements for ground, shipboard and airborne applications. AN/UPR-4(V) Passive Detection and Reporting System The AN/UPR-4(V) Difference Telephonics’ AN/UPR-4(V) was designed to meet DoD, FAA and Eurocontrol regulations to reduce 1030 MHz/1090 MHz radio frequency transmissions and interrogation rates in air traffic and military domains. AN/UPR-4(V) is a receive-only system that does not interfere with currently installed military IFF systems or civil secondary surveillance. The solution can be used as a passive cueing system, providing situational awareness to air defense and air traffic controllers with reports fed directly to mission systems and other active interrogator systems. As a queuing system, the target reports are sent to active interrogators so that they can reduce their active interrogations. The system’s receiver, processor and tracker are based on Telephonics’ DoD AIMS certified AN/UPX-44A IFF interrogator and leverages Circuit Card Assemblies (CCA) and a Commercial-Off-the- Shelf (COTS) chassis for a low-cost approach to passive detection and reporting while also providing data logging and full maintenance support capability. System Versatility Offering a single channel variant for low- to medium- density target environments and a six-channel variant for high-density target environments, the AN/UPR- 4(V) offers a wide range of fixed-mount antenna configurations. Telephonics Corporation | 815 Broad Hollow Road | Farmingdale, New York 11735 | 631.755.7000 Passive reception of Mode S ADS-B, Mode 5 Level 2, Mode 5 Level 2B and Universal Access Transceiver. AAL1871 53.4 nm 12.5 nm PIN 5856 13.8 nm PIN 5957 14.7 nm PIN 5956 15.7 nm PIN 5953 20391 17.0 nm ILM 50 75 100 120 12.5 nm PIN 5856 13.8 nm PIN 5957 14.7 nm PIN 5956 15.7 nm PIN 5953 20391 13.8 nm

Upload: others

Post on 07-Aug-2020

4 views

Category:

Documents


0 download

TRANSCRIPT

Page 1: AN/UPR-4(V) - Telephonics...AN/UPR-4(V) is a receive-only system that does not interfere with currently installed military IFF systems or civil secondary surveillance. The solution

As a benchmark innovator of Identification Friend or Foe (IFF) interrogators, Telephonics is offering its AN/UPR-4(V) Passive Detection and Reporting System (AN/UPR-4(V)). Designed in a small, yet rugged package, the AN/UPR-4(V) meets the military’s situational awareness

requirements for ground, shipboard and airborne applications.

AN/UPR-4(V)Passive Detection and Reporting System

The AN/UPR-4(V) DifferenceTelephonics’ AN/UPR-4(V) was designed to meet DoD, FAA and Eurocontrol regulations to reduce 1030 MHz/1090 MHz radio frequency transmissions and interrogation rates in air traffic and military domains. AN/UPR-4(V) is a receive-only system that does not interfere with currently installed military IFF systems or civil secondary surveillance. The solution can be used as a passive cueing system, providing situational awareness to air defense and air traffic controllers with reports fed directly to mission systems and other active interrogator systems. As a queuing system, the target reports are sent to active interrogators so that they can reduce their active interrogations.

The system’s receiver, processor and tracker are based on Telephonics’ DoD AIMS certified AN/UPX-44A IFF interrogator and leverages Circuit Card Assemblies (CCA) and a Commercial-Off-the-Shelf (COTS) chassis for a low-cost approach to passive detection and reporting while also providing data logging and full maintenance support capability.

System VersatilityOffering a single channel variant for low- to medium-density target environments and a six-channel variant for high-density target environments, the AN/UPR-4(V) offers a wide range of fixed-mount antenna configurations.

Telephonics Corporation | 815 Broad Hollow Road | Farmingdale, New York 11735 | 631.755.7000

Passive reception of Mode S ADS-B, Mode 5 Level 2, Mode 5 Level 2B and Universal Access Transceiver.

N601EC97.2 nm

JBU1650.8 nm

113243.0 nm

NKS22642.4 nm

CMP80338.7 nm

89.7 nmPIN 5668

JBU44497.2 nm

AAL187153.4 nm

12.5 nmPIN 5856

13.8 nmPIN 595714.7 nmPIN 595615.7 nmPIN 5953

360457.7 nm

2039117.0 nm

NKS94383.6 nm

RDU

PGV

ILM

MYR

50 75 100 120

12.5 nmPIN 5856

13.8 nmPIN 5957

14.7 nmPIN 5956

15.7 nmPIN 595320391

13.8 nm

PHF

Page 2: AN/UPR-4(V) - Telephonics...AN/UPR-4(V) is a receive-only system that does not interfere with currently installed military IFF systems or civil secondary surveillance. The solution

39897 ©2020 Telephonics Corporation. All rights reserved. Although the information in this document has been checked and is believed to be accurate, no responsibility is assumed for inaccuracies. Telephonics reserves the right to make changes to product descriptions and specifications at any time without notice. Telephonics and the Telephonics logo are registered trademarks of Telephonics Corporation. Other names may be trademarks of their respective holders. All claims made herein speak as of the date of this material. The company does not undertake to update such statements.

For additional information, contact Telephonics at 631.755.7000 or visit www.telephonics.com.

Small Form Factor (SFF) AN/UPR-4(V)

Rack Mount SFF-AN/UPR-4(V)

Weight 32 lb. 30 lb.

Dimensions (in.) 19 W x 6.97 H x 19.7 D 7.2 W x 9.65 H x 8.65 D

Primary Power 100-240 VAC Single Phase 50-60 Hz 24-28 VDC

Receiver Sensitivity To -94 dBm (adjustable)

To -94 dBm (adjustable)

Range >200 NM with 8 dBi Antenna and LNA

>200 NM with 6-channel Antenna and LNA

Technical SpecificationsThe AN/UPR-4(V) interfaces to both KIV-77 and KIV-78 Crypto Appliqués. Target reports are output in Ethernet ASTERIX Cat 21, Cat 48 and Cat 33. The system is compliant to DoD AIMS 03-1000B, ICAO 9871 and RTCA/DO-260B.

6-Channel Antenna

Frequency band ........................ 978 MHz and 1,090 MHzRF sectors 6 at 60° each; 360° totalPolarization ................................. VerticalMin. gain 978 MHz ..................... 22 dBiL (with LNA)Min. gain 1090 MHz ................... 27.5 dBiL (with LNA)Mast mount (Dia.) ...................... 1.5 in. IPSWeight ........................................... 17 lb. max (7.71 kg)Diameter ...................................... 7.5 in. (19.05 cm)Height ............................................ 24.69 in. (62.71 cm)Temperature, low/high .......... -55 to +85°C

Single Channel Omni Antenna

Frequency band ........................ 960 MHz to 1,215 MHzRF sectors 1 at 360° Polarization ................................. VerticalMin. gain 978 MHz ..................... 8 dBiMin. gain 1090 MHz ................... 8 dBiWeight ........................................... 8 lb. Diameter ...................................... 3.0 in. Temperature, low/high .......... -51 to +49°C

Note: Other antenna size options available

SFF AN/UPR-4(V)

Designed for Varied EnviromentsAntenna selection is based on installation size limitations, overall surveillance coverage and target density performance requirements.

Understanding the critical importance of adaptable technology, Telephonics’ design engineers included

additional capabilities such as the 978 MHz Universal Access Transceiver (UAT) and embedded GPS with an SAASM option, increasing situational awareness coverage for general aviation aircraft with embedded security for military applications.