ansi o1.1-1 (2007)
TRANSCRIPT
ANSI O1.1-1 (2007)
for Safety Requirements for Fixed Angle Jump Saws
SecretariatWood Machinery Manufacturers of America® (WMMA®)
Approved January 29, 2010
American National Standards Institute, Inc.
This is a preview of "ANSI O1.1-1-2007". Click here to purchase the full version from the ANSI store.
4
I
1111113333445556778888
This is a preview of "ANSI O1.1-1-2007". Click here to purchase the full version from the ANSI store.
Forward (This forward is not part of American National Standard O1.1-1.)
In 2002, the Accredited Standards Committee O1 (ASC O1) determined that the parent standard O1.1 was
not adequately serving the needs of its intended audiences. New machines were being introduced into the
workplace, and older machines were becoming obsolete, both at a rate not suitable for a general purpose
standard such as O1.1. Therefore, the committee set forth a process to develop a series of smaller,
machine specific standards. O1.1 would continue to be the general purpose standard for industrial
woodworking machines. Standards for specific machines or topics would use the O1.1 as an umbrella,
covering the general topics of machine and worker safety, with the new standard addressing issues unique
to the machine of interest.
This standard (O1.1-1) is the first such machine specific standard developed under the new process. It,
like all other machine specific standards to come, is maintained by a sub-committee reporting to the full
ASC O1. Questions and inquiries regarding this standard should be addressed to the ASC O1 through the
Secretariat, Wood Machinery Manufacturers of America.
Suggestions for improvement of this standard are welcome. They should be sent to the Wood Machinery
Manufacturers of America (WMMA), 100 North 20th Street, 4th Floor, Philadelphia, PA 19103-1443,
This standard was processed and approved for submittal to ANSI by the Accredited Standards Committee
O1. Committee approval of this standard does not necessarily imply that all committee members voted for
its approval. At the time it approved this standard, ASC Committee O1 had the following members:
Michael L. Gililland, Chairman Wood Machinery Manufacturers of America
Mary Bauer Occupational Safety and Health Administration
Giordano Checchi Woodworking Machinery Industry Association
Brad Graves Accu-Router, Inc.
Neal Growney (Alternate) American Society of Safety Engineers
Dave Hanson Safety Speed Cut Manufacturing
Wayne Hill Power Tool Institute
Drew Hornick (Alternate) Power Tool Institute
Jack Hyde System Safety Society
Jim Laster Newman Whitney
Chuck LeRoux Andersen Corp.
Michael McKee A.J. Gallagher RMS
Tom Onsrud C.R. Onsrud
Richard Otterbein Member At Large
Bill Perdue American Home Furnishings Alliance
Tom Pilchowski Member At Large
Bill Pritchard Kitchen Cabinet Manufacturers Association
Richard Schafebook (Alternate) Power Tool Institute
Don Snyder (Alternate) Underwriters Laboratories
John Stimitz Underwriters Laboratories
Richard Telech United Brotherhood of Carpenters and Jointers of America
Richard Titus (Alternate) Kitchen Cabinet Manufacturers Association
Al Weaver American Society of Safety Engineers
Bob Woods Masonite Corporation
Steve Ziegeweid Ashley Furniture
(Committee List as of December 2009)
This is a preview of "ANSI O1.1-1-2007". Click here to purchase the full version from the ANSI store.
1
American National Standard
01.1-1
This is a preview of "ANSI O1.1-1-2007". Click here to purchase the full version from the ANSI store.