yung chan, suman sinha ray and alexander l. yarin micro/nanoscale fluid transport laboratory...
Post on 15-Dec-2015
215 Views
Preview:
TRANSCRIPT
Yung Chan , Suman Sinha Ray and Alexander L. YarinMicro/Nanoscale Fluid Transport LaboratoryEngineering Research Facility Room 1014University of Illinois at Chicago, IL 60612
2010 NSF REU Summer Program
Hydrodynamics of Drop Impact and Spray Cooling through Nanofiber Mats
1
Outline
Acknowledgement Introduction Applications Experiments Results and Discussions Conclusion Reference
2
7/29/2010 UIC-REU
Introduction
Drop impacts on dry surface exhibit more complicated flow patterns than those on the wetted surfaces
Six possible outcomes of drop
impacts on a dry surface
Drop impact on dry surface is a key element of a wide variety of phenomena encountered in many technical applications, including spray printing, rapid spray cooling of hot surface, ice accumulation on power lines and aircrafts
4
7/29/2010 UIC-REU
Applications Spray cooling can be used to transfer large amounts of energy through the
latent heat of evaporation, heat transfer rate much higher than pool boiling since the drop can be removed heat from surface more easily.
Water Spray Cooling: extremely high heat transfer (L= 2260J/g)
cooling microelectronic chips , radiological elements and server room.
Semiconducting diamond devices works up to temperatures of 500 °C, and silicon devices fail at around 150 °C
5
7/29/2010 UIC-REU
Use minimum amount of water to transfer maximum heat from device in shorter time.
Coating that can increase the interface
Experiment- Nanofiber Mat Coating
Electrospinning is a process that produces continuous polymer fibers through the action of an external electric field imposed on a polymer solution.
Primary characteristic of nanofibers is the high ratio of surface area to mass .
Then polymer fiber distributed on the grounded plate
PAN (Poly-acrylonitrile) is a resinous, fibrous, and rubbery organic polymer.
6
7/29/2010 UIC-REU
Conclusion
Nanofiber mat coating:
Silver > Copper > Nickel > PAN
Based on cost and heat flux rate: Copper nanofiber mat is the best coating.
Copper nanofiber mat: high thermal conductivity
high interface between water and hot surface Copper nanofiber coating may lead to a breakthrough in the
development of a new generation of spray cooling process.
14
7/29/2010 UIC-REU
Reference
Alexander L. Yarin, “Drop Impact Dynamics: Splashing, Spreading, Receding, Bouncing…” Annual Review of Fluid Mechanics, Vol. 38, pp.159-192, Jan. 2006.
Darrel l H. Reneker, and Alexander L. Yarin, “Electrospinning jets and polymer nanofibers” Polymer, Vol. 49, pp.2387-2425, Feb. 2008.
Andreas N. Lembach, Yiyun Zhang, and Alexander L. Yarin, “Drop Impact, Spreding, Splashing, and Penetration into Electrospun Nanofiber Mats” Langmuir Article, Vol. 26, pp.9516-9523, Feb. 2010.
R. Srikar, A.L. Yarin, “ Nanofiber coating of surfaces for intensification of drop or spray impact cooling” International Journal of Heat and Mass Transfer, Vol. 52, pp.5814-5826, Sept. 2009.
15
7/29/2010 UIC-REU
top related