you must use the frame geometry slide from your bike presentation. decide if you want to design your...
Post on 03-Jan-2016
218 Views
Preview:
TRANSCRIPT
You must use the framegeometry slide from your bikepresentation.
Decide if you want to design your bike for a Small, Medium, Large, or Extra Large person. Your chart may be different.
1. Front Plane > New Sketch
2. Draw a horizontal construction line.This is the bottom line as shown in the Frame Geometry above.
3. Right-click on the line.Select the boat anchor to lock the line.
4. Sketch > LineDraw a path for the Seat Post (A)See the your chart for the angle and length.
5. New Plane - end of the line.Sketch a Profile Feature > Sweep Profile
Seat Tube
6. Sketch > LineDraw the Head Tube (E)See the your chart for the angle and length.
7. New Plane - end of the line.Sketch a Profile Feature > Sweep Profile
Head Tube
9. Sketch > LineDraw the Top Tube.
8. Front Plane > New Sketch
10. New Plane - end of the line.Sketch a Profile (Ellipse) Feature > Sweep Profile
Top Tube
12. Sketch > LineDraw the Down Tube.
11. Front Plane > New Sketch
13. New Plane - end of the line.Sketch a Profile (Ellipse) Feature > Sweep Profile
Down T
ube
15. Sketch > Circle.
14. Front Plane > New Sketch
16. Boss-Extrude > Mid Plane
Bracket Shell
17. Cut Extrude Seat Tube, Head Tube and Bracket Shell18. Fillet all intersections
top related