wiring & hardware setting ► catalog ► manual ► installation guide ► troubleshooting ►...

WIRING & HARDWARE SETTING

► Catalog ► Manual► Installation Guide

► Troubleshooting► Purchase Order

► IDTECK Home► e-Training Center

Between the PC and multiple devices that communicate via

TCP/IP or Serial Communication

► Catalog ► Manual► Installation Guide► Troubleshooting► Purchase OrderCopyright (c) 2008 IDTECK.

All rights reserved.

• Bypass Connection Mode

- Change Jumper Setting and Wiring for TCP/IP and slave RS422 Communication

• Connect LAN cable between RJ45 Jack of Controller #1- Connects to the network such as hubs or router : Use Direct LAN Cable- Connects to the PC directly : Use Cross LAN Cable

• Cross-connect RS422 wires between Controller #1 and Controller #2. (①)• Direct-connect RS422 wires between Controller #2 and Controller #3~#n.(②)

• Change Jumper Setting- Controller #1 : Make sure that the Jumpers(JP1~JP4) must be set to the right position.- Controller #2~#n : Make sure that the Jumpers(JP1~JP4) must be set to the left position.

USING TCP/IP INTERNAL CONVERTER

► Catalog ► Manual► Installation Guide► Troubleshooting► Purchase OrderCopyright (c) 2008 IDTECK.

All rights reserved.

USING SERIAL CONVERTER• Controller is considerably distant from PC• Electric Noise is existing around communication line• Maximum Communication Cable Length (converter to Finger007) 1,200m• RS422(multi-drop) : Multi controllers are connected to one PC - Direct connection among Controllers - Cross connection between the Controller and the Converter (TX to RX, RX to TX)

RS232C

Controller

RS422 to RS232 Converter

TX+

TX-

RX+

RX-

TX+TX-

RX+

RX-

RX+

RX-

TX+TX-

RS422

DIRECTCONNECTIONCROSS

CONNECTION

TX+

TX-

RX+

RX-

• RS422

Communication

techsupport@idteck.com

For more information,

Contact us at

Thank you.

Copyright (c) 2008 IDTECK.

All rights reserved.