william norris jwn0009 identify tool and equipment safety procedures in woodworking, welding,...

• William Norris• jwn0009

• Identify tool and equipment safety procedures in woodworking, welding, electrical, small engine, plumbing, and masonry operations.

Click to begin.

Electrical Engines Welding

10 Points

20 Points

30 Points

40 Points

50 Points

10 Points 10 Points 10 Points 10 Points

20 Points 20 Points 20 Points 20 Points

30 Points

40 Points

50 Points

30 Points 30 Points 30 Points

40 Points 40 Points 40 Points

50 Points 50 Points 50 Points

PlumbingFFA

Knowledge

What year was the FFA founded?

1928

What are the official FFA

colors?

National Blue and Corn Gold

Who wrote the FFA creed and in

what year?

E.M. Tiffany in 1930

What are the parts of the FFA emblem?

Cross section of the ear of corn, the rising sun, the owl, the plow, the eagle, and the words

What is the FFA motto?

Learning to Do, Doing to Learn, Earning to Live, Living to Serve

Does a microwave run off of a 120 volt or 240 volt circuit?

120 volt

What color is the ground wire?

Green or bare

What does the NEC stand for?

National Electric Code

What does GFCI stand for?

Ground Fault Circuit Interrupter

What kind of switch allows you to operate a light from

2 different locations?

3-way Switch

What is the difference between PVC and CPVC?

PVC is for cold water. CPVC is

for both hot and cold.

What is the purpose of the P

or S-trap?

To eliminate the odor.

What part of the hot water heater is

responsible for supplying heat to

the water?

The element

Name 3 types of pipe that are approved for

residential plumbing.

PVC, CPVC, PEX, Copper, and Galvanized

If Jesus wanted to convert a piece of PVC pipe from ¾

inch to ½ inch what materials would he

need?

A PVC reducer, PVC primer, and

glue

How many strokes does a 4-

cycle engine have?

Four

What is the difference between

a 4-cycle engine and a 2-cycle

engine?

Gas and oil are combined in a 2-

cycle engine.

Name the 4-strokes.

Compression, power, intake, and

exhaust

What is the purpose of the carburetor?

Delivers correct mixture of air and

fuel to the combustion

chamber

What is valve tappet clearance?

The distance valves open to allow

incoming mixture in and exhaust

gasses out

Name two types of welding.

Arc, mig, tig, brazing, and oxyacetylene

What is the name of the device used in

stick welding?

Electrode

What is produced when welding

chemicals and air mix?

Slag

What degree shades are

required for stick welding?

#10

What is the purpose of the negative cable

when attached to metal?

Serves as the ground to complete

the electrical circuit

Make your wager

What type of root comes out of the

pericycle?

The lateral root