tubar or turbine retrofit for dresser wayne vista 4compx.com › gssp-sheets › images ›...
Post on 08-Feb-2021
5 Views
Preview:
TRANSCRIPT
-
1
TuBAR® or Turbine®
Retrofit for Dresser
Wayne Vista 4
Copyright © 2017 CompX Security Products. Any companies and/or products referred to herein are marks or registered trademarks of their respective companies owners and/or mark holders.
Retrofit for Vista 4 Rev B
-
2
A B
C D
E
F G
CAT Door
Retrofit: Vista 4 Part # DWC-V4
Instructions
Retrofit for Vista 4 Rev B
1. Locate and remove plug from housing (Fig. 1).
2. Insert Lock ‘A’ in hole using Cylinder Nut ‘B’ (Fig.2).
3. Install Cam ‘C’ using Nut & Lock Washer ‘D’ (Fig. 2).
4. Install Bracket ‘E’ into existing holes in dispenser frame
securing with Nuts ‘F’ (Fig. 3).
5. Drill 7/32” hole in header (Fig. 4) using Bracket as a template.
6. Secure top of Bracket to header using Hex Bolt ‘G’ (Fig. 4).
-
3
Figure 1
CAT Door
Retrofit: Vista 4 Part # DWC-V4
Retrofit for Vista 4 Rev B
Locate and remove plastic plug from inside housing.
-
4
Figure 2
CAT Door
Retrofit: Vista 4 Part # DWC-V4
Retrofit for Vista 4 Rev B
Insert TuBAR Lock ‘A’ in hole, secure with Cylinder Nut ‘B’.
Attach Cam ‘C’ and secure with Lock Washer & Nut ‘D’.
-
5
CAT Door
Retrofit: Vista 4 Part # DWC-V4
Retrofit for Vista 4 Rev B
Install Bracket ‘E’ into existing holes in dispenser frame.
Secure with Nuts ‘F’.
Figure 3
Bracket
‘E’
Nuts ‘F’
-
6
CAT Door
Retrofit: Vista 4 Part # DWC-V4
Retrofit for Vista 4 Rev B
Drill 7/32” hole in header using Bracket as a template.
Install Hex Bolt ‘G’ to secure Bracket to header.
Figure 4
Hex Bolt
‘G’
Drill 7/32”
-
7
CAT Door
Retrofit: Vista 4 Part # DWC-V4
Retrofit for Vista 4 Rev B
Continue to use the
compression security
screw. Unlock locks
before releasing
pressure from security
screw and tighten
security screw before
re-locking locks.
Use CompX Part #:
SKD-CW and existing cam
TuBAR or Turbine locks are
not designed to be used as a
compression latch.
top related