toyota landcruiser 100 series 6 cyl

270121.4

L.P. GAS CYLINDER

INSTALLATION INSTRUCTIONS

TOYOTA LANDCRUISER – 100 SERIES (6 CYL ONLY)

260dia Twin Endfill Cylinders

This Automotive LP Gas cylinder must be installed in the vehicle in strict accordance with the latest requirements of

AS/NZS1425.

General Cylinder Specifications: (2 cylinders per vehicle)

DIAMETER : 260mm LENGTH : 900mm

WATER CAPACITY : 43L L.P GAS CAPACITY : 34.4L

VALVE ORIENTATION : Endfill

Installation:

1). Install the filler and filler hoses to the vehicle as directed.

2). Place vehicle on hoist and remove the front 3). Fit the attachment brackets supplied by

brackets supporting the side step on both . Manchester Tank to both of the side steps.

the left and right hand side of the vehicle. Note: The cylinders will not fit in place

without changing the side step brackets

4). Fit the brass ‘T’ piece supplied with the filler 5). Jack the left hand cylinder into position

to the left hand cylinder as shown. Note the in between the side of the vehicle and the

relief valve location when determining the main chassis. Ensure the valve is facing to

left hand cylinder. Fit the 90deg brass elbow the REAR of the vehicle.

supplied to the right hand cylinder.

6). Included with the cylinder is a bolt pack 7). Bolt the cylinder to the side of the chassis

containing bolts, washers, nyloc nuts, placing the crush tube between the cylinder

crush tubes and powder coated backing plates. bracket and the backing plates

8). When bolted in place, check the cylinders are

not making contact with either the chassis or

the floor pan of the vehicle. Repeat steps

5 – 8 for right hand cylinder

9). Connect the filler hoses to the cylinders as per AS/NZ1425 requirements

Should you encounter any difficulties with the installation of these cylinders, please contact your LPG Equipment distributor.

Do not remove the valves without authorisation from Manchester Tank.