qnet dc motor control trainer
Post on 19-Jun-2015
335 Views
Preview:
DESCRIPTION
TRANSCRIPT
QNET DC Motor Control Trainer
By FADZLI & ZOUBAIR
SPEED CONTROL
POSITION CONTROL3
1
2
MODELING
•AGENDA
Stage 1• Lab 1: Bump Test
Stage 2• Lab 2: Model Validation
Stage 3• Results
What is modeling?
Modeling is Used in many places in industry to ensurethat a part has been produced within allowable tolerances
•MODELING
•MODELING: Bump Test
Lab 2: Model Validation
Same step with bump test
Difference is put the value of
K and t
Need to match the stimulation and the actual
system
•MODELING: Model Validation
Stage 1• Lab 1: Qualitative PI
Control
Stage 2• Lab 2: PI Control
According to Specifications
Stage 3• Lab 3: Set-Point Weight
Stage 4• Results
What is Speed control?
PID control is used in a wide array of industries.Speed control is used extensively in transportation and electronics.
•SPEED CONTROL
More About Speed Control Experiment
Is controlled using a proportional – integral control system
The speed control and position control are used to demonstrate the capabilities of a control system.
•MODELING: Bump Test
•MODELING: Model Validation
Stage 1• Lab 1: Bump Test
Stage 2• Lab 2: Model Validation
Stage 3• Results
What is modeling?
Modeling is Used in many places in industry to ensurethat a part has been produced within allowable tolerances
•MODELING
•MODELING: Bump Test
•MODELING: Model Validation
•SUMMARY
motion control feedback systems PID Modeling Speed control Position control
Concepts learned in the DC motor Control Trainer
Thank YouTHANK YOU
top related