porsche cayenne(2011-) electronic parking brake pads...
Post on 23-Jan-2021
2 Views
Preview:
TRANSCRIPT
1/20
Porsche Cayenne(2011-) Electronic Parking Brake Pads Replacement
功能说明:
注意事项:
操作指引:
l This function can safety protact your EPB system.
l The main function including release the handbrake to the mounting position,Check
the parking brake basic settings (check brake gap) and Brake pads run and calibration and other operations.
l Cayenne rear brake pads replacement is the same as traditional pads.If you accidentally click on the
"Handbrake tablets to the installation position" menu, you must strictly follow the steps of the maintenance
index, electronic hand brake can be restored to normal.
l After replaceing pads, please run"Check the parking brake basic settings" to make sure the gap is standard
(1.9mm-2.4mm) before you go on next proceeding.
l Replace the brake must be carried out after "Run-in" then start "Calibration".
1).Select Porsche after version 21.51
2).Cayenne(since 2011)->System->Parking brake->Special Function,
3/20
4/20
4).Choose “Handbrake tablets to the installation position”, please follow the prompt then replace pads,after finished replacement choose“Check the parking brake basic settings”.
5/20
6/20
5).Press"Yes",Actuator will complete a pull in and then release process.
7/20
Picture 4
8/20
6).Press "Next" then check the gap. Note: Cayenne(since 2011) should from
1.9mm to 2.4mm, if the gap not in this range please adjust it by hand.
9/20
7).Press "Next", then finish "Check the parking brake basic settings" function.
2017/11/24 保时捷卡宴(2011-)电子驻车制动片(手刹片)更换操作
11/20
8).After adjust the gap, choose "Run-in" function;
13/20
9).After replaced pads, run-in is necessary. Its equal to adaptive learning,then dash board will prompt
"Parking system into maintenance mode" , and this function need to repeat 8 tims with 2 workers. One is driving
another is operating. Please fully prepared for this test. You can only get on "Calibration" after 8 times
are all succeed.
15/20
16/20
10).Choose "Calibration";
17/20
18/20
11).Fulfilled all conditions then can go on "Calibration". At last software will prompt you all operation is done.
19/20
top related