melitta bar-cube ii - planerhandbuch bar-cube ii/downl… · ® bar-cube ii dimension and data ......

Sirup: ohne mit Größe: S M L

Schoko

Milch: 1 2

Espresso Cappucciono

Heißwasser

Latte Macchiatio

Subject to alterations.Ownership of Melitta System Service.Duplication not allowed.

Date: 03/2011

Page: 2 of 2 Melitta® bar-cube IIDimension and data sheet

Chg. Name Date

The Melitta® bar-cube is delivered ready for connection. However, before setting up the necessary connections must be installedon site easily accessible within a radius of 1m. This preliminary work must be performed by licensed professionals in strict compliancewith valid regulations. The Melitta® customer service is not authorized for and does not take any responsibility for the installation.

The machine must be placed on a level tabletop. The supply lines must be routed up from below. A hole of approx. Ø 120 mm (1)must be drilled in the tabletop under each machine as feed-through for connecting hoses and electric supply lines. For machines withcontainer drop (optional) another hole with approx. 120 mm Ø (2) must be drilled.

*With the fitted feet the machines can be raised by approx. 15 mm.

Machine data:Hourly output: 20-25 ltr. Hot water Dimensions (WxDxH): 430 x 500 x 695 mm approx. 100 cups of coffee Weight approx.: 47 kgPermitted ambient temperature: 5 °C - 30 °C Provision of coffee beans: 2 x 1100 grPermitted relative humidity: < 80 % non-condensing Instant container provision 2 x 500 grNoise level: < 70 dB(A) Grounds drawer capacity: for approx. 25-30 portions Tapping depth: > 40 mm

Electrical connection (a):Mains connection: 230 V / 50 HzPower consumption: 2.8 kW max.Fuse on site: 16 A requiredConnection: Power cable 1.8 m with grounded line plug

The connection must be made via an easily accessible CEE socket.This socket must be protected by a ground fault circuit breaker (max. 30 mA).

Water supply connections (b):Fresh water connection: G 3/4” male thread

According to the regulations of the German Association for Gas and Water (DVGW) a stop cock with backflow preventer must beinstalled in an easily accessible place by the customer. A special connection hose is supplied. For safety reasons, this hose must notbe shortened.

Fresh water pressure: min. 0.25 MPa (2.5 bar) at approx. 2 l/min., if it is more than 0.6 MPa (6 bar) static, a pressure regulator is required.

Carbonate hardness of tap water: 1° dKH - 3º dKH no action required, from 4° dKH decarbonizer (Brita-Purity) required, below 1° dKH you should contact Melitta® SystemService.

Waste water connection: min. DN25-NW1"

The Melitta® bar-cube is equipped with a socket for drainage of the trip dray and is to be connected to the on-site drain using thesupplied hose. The required odour trap can be supplied by Melitta® customer service.

Optional accessories:- lockable bean container- Container drop- Water filter- Pressure reducer- Odour trap

1) ø 120 mm for supply and drain line applies not for machines with an undertable refrigerator (order-no.:21394)2) ø 120 mm for container drop (optional) not for machines with an undertable refrigerator (order-no.:21394)

Melitta® bar-cube II 1C-2G/ISRequired clearance above thebean container min. 200 mm

Attention: All dimensions are approximate!

a

min. 600m

in. 6

50

bCabinet depthmin. 650 mm

8513

910

0

493*

665*

695*

Atte

ntio

n: m

ax. i

nsta

llatio

n de

pth

350

mm

!

801

350

530

01 Gen/Pa 07/09/2011

380

1

2

216

500

430

min. 100 mm wall clearance

240

Wat

er fi

lter

Attention: Observe the swinging area!

02 KH/Pa 12/2011

03 UKL/Pa 04/2012

295

100

3

min. 100 mm wall clearance

Available extension modules and billing systems (optional): Melitta® bar-cube II mc-cw - milk cooling cabinet with cup warmer (Order-No.: 23824), W=280, D=410 mm, H=465 mm, Electrical connection V/A: 230/16, Rated power: 0.15 kW Melitta® bar-cube II mc-built-in refrigerator - (Order-No.: 21394), W=430, D=465 mm, H=219 mm, Electrical connection V/A: 230/16, Rated power: 0.135 kW Attention: not possible for machines with a container drop! Melitta® bar-cube II cw-mp - cup warmer with coin verifier (Order-No.: 21934), W=280, D=410 mm, H=465 mm, Electrical connection V/A: 230/16, Rated power: 0.15 kW Melitta® bar-cube II mc-mp - milk cooling cabinet with coin vwerifier (Order-No.: 23821), W=280, D=410 mm, H=465 mm, Electrical connection V/A: 230/16, Rated power: 0.15 kW Melitta® bar-cube II mc-cr - milk cooling cabinet with card reader (Order-No.: 23822), W=280, D=410 mm, H=465 mm, Electrical connection V/A: 230/16, Rated power: 0.15 kW Melitta® bar-cube II cw - cup warmer to warm up approx. 80 - 120 cups (Order-No.: 21511), Electrical connection V/A: 230/16, Rated power: 0.135 kW

Melitta® bar-cube IIextension modules

Dimension and data sheetChg. Name Date

KH/Pa

Sirup: ohne mit Größe: S M L

Schoko

Milch: 1 2

Espresso Cappucciono

Heißwasser

Latte Macchiatio

Sirup: ohne mit Größe: S M L

Schoko

Milch: 1 2

Espresso Cappucciono

Heißwasser

Latte Macchiatio

465*

172

243*

Sirup: ohne mit Größe: S M L

Schoko

Milch: 1 2

Espresso Cappucciono

Heißwasser

Latte Macchiatio

Sirup: ohne mit Größe: S M L

Schoko

Milch: 1 2

Espresso Cappucciono

Heißwasser

Latte Macchiatio

Sirup: ohne mit Größe: S M L

Schoko

Milch: 1 2

Espresso Cappucciono

Heißwasser

Latte Macchiatio

500

430280

410

min. 100 mm wall clearance

70

Sirup: ohne mit Größe: S M L

Schoko

Milch: 1 2

Espresso Cappucciono

Heißwasser

Latte Macchiatio

695*

219*

12/2011 Subject to alterations.Ownership of Melitta System Service.Duplication not allowed.

Date: 03/2011

Page: 2 of 2

Attention: All dimensions are approximate!

3) Hole in tabletop for machines with an undertable refrigerator (order-no.:21394) ø 120 mm for supply and drain line

UKL/Pa 04/2012

01

02