josun factory visit

Josun Factory VisitRaymond Tan

This is a pictorial booklet featuring our facilities and equipment in our production plant in Jiangsu, China.

Featured also are some of the components of foreign makers like ABB, Emerson, Schneider, Danfoss, Carrier, Bitzer being used in most of our equipment.

Running of tests and commissioning are the final phrase of the production before our products are delivered to our customers. Some of these tests are featured towards the end of the booklet.

Finally, the last of those pictures are some of the departments housed in our institute where we design our products and equipment.

Josun Factory Visit

Josun Air Conditioner Co., Ltd is China largest marine refrigeration equipment maker and we are located in Taixing in Jiangsu province about 3 hours drive from Pudong Airport (Shnaghai).

Although our factory is located in the Economic Development Zone, the nearest hotel is only 3 mins drive away and the town is about 10 mins.

Josun Air Conditioner

Package or Self Contain Unit

Electrical components like emerson and schneider are used in most of the equipment manufactured here. Customer’s request can be integrated into also.

Picture on the right featuring the piping and valves running from compressors to evaporator coil.

Picture below shows a worker working on the compressor.

Next page- the evaporator with a steam or hot water heater in front.

Refrigeration Equipment (AHU)

CondenserThis plastic tube is used to prevent erosion of wielding between the tubing and the plate.

Evaporator sitting on top of a condenser used in the water chiller system

Below-a fan being attached to a tunnel for measuring of air flow and volume. Right-the equipment used for the test.

Previous page: clockwise-centrifugal fans , an inclined manometer, axial fans with ABB ex-proof fitted.

Fan

Previous page - machines used in production of fins for the evaporator coils.

On the right and clockwise-sheet metal shear machine, turning machine, electrical assembly workshop, steel plate stamping machine.

Below (L)- unfinished evaporator fins.

Below (R)- blazing of copper pipes of evaporator

Workshops

Above is the refrigeration testing centre, one of the test lab in the factory.

Filling up evaporator coil with nitrogen and submerging to water to test for leaking. Some of the refrigeration system being connected to water supply to run the system to be tested.

Electrical and Fan Design Rooms

A New Design Dept and the AC Design Dept

Air Handling Unit

Hotel Lobby (hotel is about 3 mins drive from factory).

Thank you for viewing.Raymond Tan