handoff schemes overview and guidelines for handoff procedures
Post on 09-Feb-2017
232 Views
Preview:
TRANSCRIPT
Handoff Schemes Overview and Guidelines for Handoff Procedures in 802.16
IEEE 802.16 Presentation Submission Template (Rev. 8.3)Document Number:
IEEE S802.16sgm-02/24Date Submitted:
2002-09-19Source:
Avi Freedman Voice: +972-3-5101128Hexagon system Engineering Ltd. Fax: +972-3-51033312 Kaufmann st. E-mail: avi@hexagonltd.comTel-Aviv, 68012, Israel
Zion Hadad Voice: +972-3-9528440Runcom Technologies Ltd.2 Hhacoma st E-mail: zionh@runcom.co.ilRishon le-zion, Israel
Venue:Meeting #21, Cheju, South Korea
Base Document:IEEE C802.16sgm-02/24 <http://ieee802.org/16/mobile/C80216sgm-02_24.pdf>.
Purpose:Disccussion
Notice:This document has been prepared to assist IEEE 802.16. It is offered as a basis for discussion and is not binding on the contributing individual(s) or organization(s). The material in thisdocument is subject to change in form and content after further study. The contributor(s) reserve(s) the right to add, amend or withdraw material contained herein.
Release:The contributor grants a free, irrevocable license to the IEEE to incorporate material contained in this contribution, and any modifications thereof, in the creation of an IEEE Standardspublication; to copyright in the IEEE’s name any IEEE Standards publication even though it may include portions of this contribution; and at the IEEE’s sole discretion to permit others toreproduce in whole or in part the resulting IEEE Standards publication. The contributor also acknowledges and accepts that this contribution may be made public by IEEE 802.16.
IEEE 802.16 Patent Policy:The contributor is familiar with the IEEE 802.16 Patent Policy and Procedures <http://ieee802.org/16/ipr/patents/policy.html>, including the statement "IEEE standards may include theknown use of patent(s), including patent applications, provided the IEEE receives assurance from the patent holder or applicant with respect to patents essential for compliance with bothmandatory and optional portions of the standard." Early disclosure to the Working Group of patent information that might be relevant to the standard is essential to reduce the possibilityfor delays in the development process and increase the likelihood that the draft publication will be approved for publication. Please notify the Chair <mailto:chair@wirelessman.org> asearly as possible, in written or electronic form, if patented technology (or technology under patent application) might be incorporated into a draft standard being developed within the IEEE802.16 Working Group. The Chair will disclose this notification via the IEEE 802.16 web site <http://ieee802.org/16/ipr/patents/notices>.
2
Handoff Schemes Overview andGuidelines for Handoff Procedures in
802.16
Avi Freedman
Hexagon
Zion Hadad
Runcom
3
Purpose
• Survey handoff schemes in cellular andWLAN networks
• Present guidelines for handoff supportin 802.16
• Offer handoff support within theframework of the OFDMA PHY
4
Definition
• Handoff - a basic mobile network capabilityfor dynamic support of terminal migration
• Handoff Management - the process ofinitiating and ensuring a seamless andlossless handoff of a mobile terminal from theregion covered by one base station toanother base station
5
Handoff Basics
• Measurements – UL and DL same andneighbor BS’s
• Decision – when and where to hand themobile terminal over
• Execution – transferring traffic and control toanother BS
6
Types of Handoffs
• Location of the HO
Execution
Mobile InitiatedHO
NetworkInitiated HO
Decision
MobileEvaluated HO
NetworkEvaluated HO
Measurements
MobileNetwork
7
Types of HO
• Network Elements Involved
IntraSector
Intracell
InterLayer
Intercell
Intersystem
8
Types of HO
• Number of active connections– Hard handoff: 1 connection active at a
time, “break before make”
– Soft Handoff: >1 connection at a time
– “make before break”
9
Types of HO
• Types of data transferred– Circuit Switched
– Packet Switched
10
Requirements for HO
• Latency: The time required to effect the handoffshould be appropriate for the rate of mobility of themobile terminal, as well as the nature of datatransferred.
• Scalability: The handoff procedure should supporthandoffs within the same cell, between different basestations in the same or in different networks
• Minimal drop-off and fast recovery• QoS maintained or re-negotiatied• Minimal additional signaling
11
Handoff Implementation
• Cellular SYSTEMS– 2G (GSM)
– 3G (UMTS)
• Wireless LAN– 802.11
– HIPERLAN 2
• Mobile IP
12
The Cellular Network
• MS – Mobile Station
• BTS – Basestation TransceiverStation
• BSC – Basestation Controller
• MSC – Mobile Switching Center
• HLR – Home Location Register
• VLR – Visitor Location Register
• EIR – Equipment Identity Register
• AuC – Authentication Center
BTSMS BTS BSC
Base Station
MSC
EIR
HLR VLR
AuC
OtherMSC
ExternalNetworks
Other
VLRs
BTS
13
GSM
• Types (network elements)– Intracell HO– Inter-Cell HO within the same BSC– Intra MSC HO– Inter MSC HO
• Types (function location)– Mobile initiated– Network initiated, mobile assisted
14
GSM (cont.)
• Measurements of the BroadcastChannel on a free time slot
• Decision according to:– Minimum acceptable performance
power control is preferred over HO
– Power budget algorithms
HO is preferred over power control
15
UMTS
• Intra-system Handover:• Intra-frequency HO
• Inter-frequency HO
• Inter-system HO• Different radio access technologies (e.g.
UMTS and GSM/EDGE)
• Different radio access modes (e.g.FDD/WCDMA and TDD/TD-CDMA)
16
UMTS (cont.)
• Soft Handoff– For intra frequency HO
– Active set controlled by the Radio NetworkController, based on mobile measurements
• Hard handoff– For inter-frequency HO, multi-layer
– Network evaluated, based on mobilemeasurements
17
UMTS (cont.)
• Compressed Mode can be used to provide“peeping window” in other frequencies
• Mobile required to monitor up to 32 BS in oneor two frequencies
• Broadcast channel and Primary CommonPilot channels are used by the HO process
• Measurements are filtered with 50-200µssymbols- for 60km/h mobiles
18
802.11
STA- Station
AP – Access Point
DS – Distribution System
BSS- Basic Service Set
ESS- Extended Service Set
ESS
19
802.11 – Mobility Types
• No Transition– Static
– Local movement
• BSS Transition
• ESS Transition
20
802.11 Process
• Use of the re-association DS service
• Handoff is mobile initiated, hard handoff
• Beacon frames are used forsynchronization and measurements
21
HIPERLAN 2
• Consists of a number of Access Pointsand Mobile Terminals
• Centrally controlled:– In centralized mode: controlled by an AP
– In Direct mode: by one MT serving as CC
• Handover is restricted to business andpublic applications
22
HL2- Function and Capabilities
• Functions:– MT Absence– Handover, determined by the CC (Radio Resource
Controller
• Capabilities– Association of MT to logically distinct subnetworks– Informing the core network of the changes of the
population associated to a subnetwork– Monitoring of radio conditions for handover and
for informing user and hosting core network of theprevailing radio/traffic conditions
23
HIPERLAN 2 (cont.)
• HL2 shall support:– Roaming between access networks– Continuous while in motion
• Rate of movement supported:– 10 m/s linear– 180 deg/sec rotation
• Packet loss or delay- to be handled byhigher layers
24
Mobile IP
• A solution to direct IP packets to a user connectedvia different access points
Home region
HomeAgent
Foreign region
ForeignAgent
Care-of-address
Mobile Terminal
25
Handoff Aware Wireless Access Internet InfrastructureHAWAII
• Reduces network load by handling local HO withinlocal area
Mobile Terminal
Routing information
Mobile Terminal
26
Terminal Independent Mobile IPTIMIP
• The network is aware if a terminal hasmobile IP capability
• Basic parameters of the the mobile– Obtained by the network at an offline
registration process
– MIP is run by the network gateway ifmobile lacks MIP capability
27
Cellular IP
• Uses layer 2 information
• Predicts possible handover
• Triggers Level 3 procedures beforeconnection
28
Guidelines for 802.16 HO Procedures
– Mobile initiated
– Mobile evaluated
– Network initiated
– Network evaluated
– Intra sector
– Intra cell
– Inter cell
– Inter layer
– Inter system
Provide HO support of higher layers
29
Requirements for 802.16 HO Procedures
• Measurements of signals of neighboringbase stations, in the same or in otherfrequencies
• Broadcasting of base station information
• Enabling intra-frequency handoff
• Enabling soft and softer handoff
30
Requirements for 802.16 HO Procedures
• Means for authentication and serviceverification
• Mechanisms for inter-mode handoveramong the various 802.16 PHYs and theiroptions
• Support Mobile IP in both IPv4 and IPv6
• Provide signal strength and otherindications for Cellular IP support
top related