dynamical downscaling of ccsm using wrf yang gao 1, joshua s. fu 1, yun-fat lam 1, john drake 1,...
Post on 18-Dec-2015
216 Views
Preview:
TRANSCRIPT
Dynamical Downscaling of CCSM Using WRF
Yang Gao1, Joshua S. Fu1, Yun-Fat Lam1,
John Drake1, Kate Evans2
1University of Tennessee, USA
2Oak Ridge National Laboratory, USA
9th Annual CMAS Conference, Chapel Hill, North Carolina October 11, 2010
Motivation
The Community Earth System Model (CESM) is being used to simulate IPCC AR5 scenarios.
To study climate change on regional and local scales, downscaling becomes an important technique to link global and regional models.
There are high uncertainties in regional climate downscaling. Different sensitivity cases are needed to optimize the regional climate simulations.
Linkage from Global model to Regional Model
Community Earth System Model
CESM 1.0
Regional Climate Model
WRF 3.2.1
36 km by 36km CONUS
D1: 12 km by 12km domain
D2: 4km by 4km Eastern US domain
Community Land Model
(CLM)
Community Atmosphere Model (CAM)
Community Sea Ice Model
(CSIM)Ocean component
(POP)
1 degree by 1 degree
3 hourly resolution
(D1)(D2)
Global and Regional Model Configurations
Most of the physics schemes are different in CESM and WRF except radiation scheme
3.5-day overlapping run segments in January, April, July and October in 2002
• Typical Analysis Nudging vs. No nudging
Horizontal wind components (U and V) in all layers
Temperature (T) and Water vapor mixing ratio (Q) above the PBL
2) Scheme options comparison:
CAM/CAM vs. RRTMG/RRTMG for shortwave/longwave radiation
WRF: CAM 3 (A spectral-band scheme used in the NCAR Community Atmosphere Model (CAM 3.0) for climate simulations.)
CESM (CAM4): (Parameterizations of shortwave and longwave
Radiation in CAM3 and CAM4 are the same)
Sensitivity Scenarios
CESM (Temperature) METGRID
Time: 2002-04-01-00:00
Patterns and Spatial distribution are similar
CCSM (Skin T) METGRID
(Relative Humidity) (Wind Vector)
Initial condition integrity
Comparison between CESM and WRF
We mainly focus on the following parameters comparison on the surface layer:
10 m Wind speed*, 10 m Wind direction*, 2 m temperature, 2 m specific humidity and precipitation
(*Note: CESM does not output 10 meters wind speed and wind direction, so the lowest model layer (around 60 m) values are used for the comparison)
Temperature at 2 meters
Dashed time series represent 2m temperature from CESM
Overall, temperature with RRTMG rw/lw radiation scheme and with nudging has lower bias than the other two cases.
Correlation between temperature bias and temperature
There is high relationship between the temperature and the bias. Bias tends to change from positive to negative when the temperature from CESM increases.
Specific Humidity at 2 meters
CAM and RRTMG schemes perform similar with each other. Nudging performs better for most of the sub-region than no nudging case. The biases are mainly ranging from -2 to 2 g/kg.
Wind Speed bias at 10 meters
Most of the cases, wind speed has negative bias.
The two radiation schemes have quite similar performance on wind speed.
Wind direction bias at 10 meters
Overall, nudging case has much lower bias than no nudging for wind direction. Radiation schemes does not have much impact on the wind directions.
Precipitation bias
Small bias in January, April and October. In July, WRF predicts more precipitation than CESM.
Comparison of WRF output with observational data
Climate data may not represent a specific year. We try to evaluate how far the WRF downscaling simulations compared with Meteorological Assimilation Data Ingest System (MADIS) observational data.
Overall, RRTMG radiation scheme with nudging performs better than the other two cases, so we only compare WRF output with observational data for the RRTMG/NUDGING case.
Wind Speed at 10 meters
Mean obs Mean prd Bias
Comparison between MADIS and WRF OUTPUT
Compared with observational data, the biases of wind speeds are within 2 m/s for most of the sub-region.
Wind direction is also comparable with observational data.
Wind Direction at 10 meters
Mean obs Mean prd Bias
Mean obs Mean prd BiasSpecific humidity at 2 meters
Comparison between MADIS and WRF OUTPUT
The bias of temperature and specific humidity ranges from -2 to 2 degree and -1 to 1 g/kg, respectively.
Mean obs Mean prd BiasTemperature at 2 meters
• Overall, nudging case performs better than no nudging case.
• RRTMG radiation scheme with nudging case shows the lowest bias for temperature compared with CAM radiation scheme and no nudging case.
• There is high relationship between the temperature and the bias. Bias tends to change from positive to negative when the temperature from CESM increases.
• WRF simulations driven by CESM are comparable to the observational data, and the range of biases for temperature, wind speed, specific humidity are from -2 to 2 degrees , from 1 to 2 m/s and from-1 to 1 g/kg, respectively.
Summary
Downscaling from CESM to WRF for12km by 12km CONUS domain and 4km by 4km Eastern US domain
Chemistry Downscaling from CESM to CMAQ
Future work
Thanks for your attention!
Questions?
top related