dialogic system

May 3, 2023

Presented by:V. R. Prabu[12 ET 14]M.E-EST

1

DIALOGIC SYSTEM

[ DTMF BASED ROBOT CONTROL METHOD ]

May 3, 2023

INTRODUCTION

2

DTMF Mobile ROBO is a machine that can be controlled with a mobile . In this project, the robot is controlled by a mobile phone that makes a call to the mobile phone attached to the robot.

if any button is pressed, a tone corresponding to the button pressed is heard at the other end of the call. This tone is called "Dual Tone Multiple-Frequency" (DTMF) tone.

May 3, 2023

ABOUT DTMF TONE

3

DTMF uses a combination of two (one low frequency and one high frequency) tones to identify the dialled number or a signal. Eight such frequencies are assigned to the four rows and four columns of a typical push-button type dial (keypad).

This method for control using the DTMF tone generated when the user pushes mobile phone keypad buttons or when connected to a remote mobile system.

May 3, 2023

DIAL PAD

4

May 3, 2023

The major building blocks of this project are:

5

GSM Modem/ Mobile PhoneDTMF DecoderMicrocontroller based Control UnitMotor driver ic.

May 3, 2023

BLOCK DIAGRAM

6

May 3, 2023

OPERATION

7

Receiving a set of command in the form of DTMF tones and performs the necessary actions.

We will be using a dedicated modem/mobile at the receiver module. It send the commands using DTMF tones as per the required actions.

DTMF decoder takes the responsibility of decoding the tones received and perform the corresponding predefined tasks such as move front or back, left or right etc.

The micro controller is pre-programmed and also interfaced with few DC motors in order to move the robot in different directions.

May 3, 2023

PIN DIAGRAM

8

May 3, 2023

BLOCK DIAGRAM OF DTMF IC 8870

9

May 3, 2023

DTMF DATA OUTPUT :

10

May 3, 2023

H – BRIDGE METHOD

11

May 3, 2023

CURRENT FLOW DIRECTION

12

May 3, 2023

L293D CONNECT WITH DC MOTOR

13

May 3, 2023

CONNECTION FROM MOBILE :

14

May 3, 2023

CONNECTION DETAIL

15

May 3, 2023

CONCLUSION

16

In the present project DTMF technology has been used to control the stepper motor at a desired direction which in turn may be used in deferent application areas. As conventional RF wireless system has distance limitation. But in this project working range as large as the coverage area of the service provider. The system developed in this project is very much simple and cost effective. It provides the advantage of robust control.

May 3, 2023

REFERENCE

17

http://www.techopedia.com/definition/26023/dual-tone-multifrequency-dtmf

http://www.webopedia.com/TERM/D/DTMF.htmlhttp://www.genave.com/dtmf.htmhttp://

www.businessdictionary.com/definition/dual-tone-multi-frequency-DTMF.html#ixzz2OFK0q2rS

http://www.electroons.com/8051/electroons/dc_motor_control.html

May 3, 202318

THANK YOU

May 3, 2023

?Queries…

19