covid-19 at home - abbott panbio covid-19 rapid antigen
Post on 09-Feb-2022
6 Views
Preview:
TRANSCRIPT
• Insert the swab ~2cm into your child’s nostril.• Rub and rotate the swab 5 times and repeat for the other nostril
(may tickle and cause eyes to water)
• Twist off the white dropper cap from the bottom of the test tube. • Gently squeeze 5 drops into the round well of the test cartridge
• Gently tap the test tube to bring the fluid to the bottom. • Remove the blue cap and immerse the swab tip into liquid. • Swirl up and down for 10 seconds. • Pinch the tube around the swab to squeeze out excess liquid.
• Wait 15 minutes for the sample to move across the white strip before reading results.• Record and submit results before discarding contents in Ziploc and garbage disposal.• See next page for instructions on reading your results
• Find the break line on the swab handle and snap at this line.• Screw blue cap back on the test tube with the other half of swab remaining
inside the tube
COVID-19 AT HOME - ABBOTT PANBIO COVID-19
RAPID ANTIGEN TEST KIT INSTRUCTIONS
Your testing kit contains:
a) Nasal swab
Scan for instructional video
1
4
2
5
3
b) Plastic test tube with small amount of clear liquid
c) Test cartridge
Your testing kit contains:
Abbott PanBio COVID-19 Rapid Antigen Test Kit Instructions
1
2
3
4
5
a) Nasal swabb) Plastic test tube with small amount of clear liquid
c) Test cartridge
Before you start: 1) Sanitize your hands 2) Lay paper towel on a clean,level surface 3) Open the contents of your
testing kit 4) Have a timer ready
Insert the swab ~2cm into your child's nostril.
Rub and rotate the swab 5 times and repeat for
the other nostril (may tickle and cause eyes to water)Gently tap the test tube to bring the fluid to the bottom. Remove the
blue cap and immerse the swab tip into liquid. Swirl up and down for 10
seconds. Pinch the tube around the swab to squeeze out excess liquid.
Find the break line on the swab handle and snap at this line.
Screw blue cap back on the test tube with the other half of swab
remaining inside the tube
Twist off the white dropper cap from the bottom of the test tube. Gently
squeeze 5 drops into the round well of the test cartridge
Wait 15 minutes for the sample to move across the white strip before reading results.
Record and submit results before discarding contents in Ziploc and garbage disposal.
See next page for instructions on reading your results
Scan for instructional video
Before you start:1) Sanitize your hands
2) Lay paper towel on a clean, level surface
3) Open the contents of your testing kit
4) Have a timer ready
COVID-19 AT HOME - ABBOTT PANBIO COVID-19
READING & REPORTING YOUR PANBIO TEST RESULT
NEGATIVE Result:
INVALID Result:
POSITIVE Result:
!
One line at the C mark, no line at the T mark
C = Control T = Test
C = Control T = Test
If your test result does not match either the NEGATIVE or POSITIVE examples above, the test may not have worked. Please contact your school’s program administrator to request a new testing kit.
Two lines: one at the C mark and one at the T mark
Important:A negative test still means you should follow public health recommendations, including wearing a mask, washing your hands frequently, socially distancing. A negative test is only valid for the day. You could become positive after today.
If you develop symptoms at any point, or come in contact with a known COVID-19 contact, please book a lab-based validation test.
Reporting:Please report EITHER result online by scanning this QR code:
Important:A positive test cannot confirm COVID-19 with certainty. Since your test indicates a potentially positive test result, please:
1) Receive a lab-based validation test within 24 hours or as soon as possible; 2) the sole care giver, child with the potential positive and any household member not fully vaccinated will need to self-isolate until you receive further direction.
top related