brass catcher for pardini cal · brass catcher for pardini cal .22 designed and developed by cap...

Brass catcher for Pardini cal .22

Designed and developed by Cap Création SAS - 03/20 - contact@easypasters.com

IMPORTANT : THIS PRODUCT IS MADE IN 3D PRINTING, PLEASE RESPECTTHE TERMS OF USE TO GUARANTEE ITS DURATION IN TIME.

THINK TO REMOVE THE NET FOR TRANSPORT ....

DISASSEMBLE THE ORIGNAL BOTTOM AND INSERT THE BOTTOM SUPPORTIN PLACE, DO NOT FORGOT THE ORIGNAL LOCK PIECE.Note : The manufacturing process does not allow continuous dismantling ofthe new bottom (it is preferable to leave it in place).

THE NET IS INSERTED OR REMOVED FROM THE SUPPORT BYTAKING IT BY THE SIDES OF THE FOOT AND NOT BY THE FRAMEWORK.

Brass catcher for Pardini cal .22

GOOD POSITION ON THEMAGAZINE.

BAD POSITION ON THEMAGAZINE (REVERSED).

NOTE:FOR COMPETITORS, IT IS NECESSARY TO POSITION THE GUN WITH THE BRASSCATCHER ON THE BOTTOM OF THE CONTROL BOX.

Designed and developed by Cap Création SAS - 03/20 - contact@easypasters.com

THE CURVED PART OF THENET MUST BE IMPERATIVELYON BOLT FRAME SIDE .CHECK THE HEIGHT LEVEL.