assembling cat5 utp cable - (scppn part 6)

Assembling CAT 5 UTP Cable

Step 1: Cut a Length of Cable

Be sure to measure the required length of the cable before cutting.

Step 2: Strip off the Jacket

• Use a wire stripper as shown.• A sharp knife or cutter may be

used but be careful not to “nick” the wires inside.

• Strip about 2.5 centimeters

Step 3: Separate the Wires

Step 4: Untwist the Wires

• Untwist the wires in a way such that it would be easy to arrange.

Step 5: Organize and Flatten Wires

Straighten the wires and arrange according to standard.

Step 6: Clip the Wires

Cut the wires evenly at the end.

Step 7: Insert Wires into RJ-45 Plug

• Insert the wires in the RJ-45 connector.

• Be careful not to disarrange the wire.

• The jacket must reach the point indicated by the arrow in the figure.

Step 8: Push the Wires In

Push the wires inside the connector until you see all the wire copper conductors.

Step 9: Inspect the Color Code

Note: Be sure the jacket reaches the point indicated above.

Step 10: Crimp Down the Wires

NOTE: Crimp firmly to secure electrical connection.

Step 11: Inspect Both Ends

Step 12: Test the Quality of Cable