angular joint - argineering.net · tips and tricks when you use joint to mount angular make sure to...

ANGULAR JOINTAssembly Guide

RGKit ACCESSORIES

3

x2 x2x2 x2 x7

x2

x3

4

Tips and Tricks

When you use Joint to mount Angular make sure to follow those tips and tricks.

1. Use Angular Elevated Mounting option.

2. Place Angular as close to the corner as possible.

3. It’s preferable to use it with a design that moves sideways, and not up and down, to avoid the weight load on Angular. The design should be on hinges.

5

Your Design/Door

6

1.

Apply White Glue

7

Wait until the white glue dries. The duration depends on the instructions on your glue.

8

2.

9

3.

10

4.

11

5.

12

6.

7.

14

8.

Make sure that Joint is not fastened too tight or too loose. The parts should be able to move freely without falling apart.

16

9.

17

10.

18

11.

19

12.

20

13.

Open the design/door to the maximum, and mark where the screw is. Make sure the angle is more than 90 degrees and less than 180, and that there is minimal distance between Angular and the axis your design will pivot on.

21

Your Design/Door

22

13.

Your Design/Door

RGKit Accessories V 2.0Designed by Argineering. Cairo, Egypt.©2019 Argineering. All rights reserved.

argineering.net