3 circulating pumps - salmson · moteur pompe vitesse (tr/min) p1 (w) i1 (a) entraxe raccordement...
Post on 12-Sep-2018
214 Views
Preview:
TRANSCRIPT
CELCIUX
3
5
00 2,5 Q m3/h
H m
Celciux
This circulating pump is suitable only for drinking water.For accelerated circulation in domestic water systems.• Domestic and small collective installations
To obtain domestic hot water as soon as the taps are turned on
RANGE OF USEFlow rate up to 2,5 m3/hManometric head up to 5 mMax. operating pressure 10 barMax. temperature in circuit + 80°CMax. temperature Circulating pump + 110°CMax. ambient temperature + 40°CHardness of the water (TH) 35°fND of ports DN 25 (1”1/2)
APPLICATIONS
ADVANTAGES
• Saves energy High performance motor and technology
• Reliability
• Easy selection
• Fast and easy to install
• Preserves the quality of the water
G1”1/2
G2”
• Adaptor rings 1½” - 2” Ref. 4051850
• Celciux
CIRCULATING PUMPS HIGH PERFORMANCE
Bronze Body Domestic hot water
50 Hz
N.T. No 111-15/ENG - Ed.4/07-14
Certified
1
CELCIUX
0
4
5
2
1
3
0 0,5
0 2 4 6 8
1 1,5 2 2,5
∆p-v
max.
min.
H m
Q m³/h
Q imp.gpm
CELCIUX
00 1 2 3 4
0,2 0,4 0,6 Q l/sQ l/min
DESIGN Hydraulic Part - Body with threaded ports for fitting direct on pipework
- Body of pump: Bronze
• Motor- Monophase, wet runner, bearings lubricated by the fluid pumped.
- Self-adjusting, adapts to the pressure requi-red by the installation.
- Self-protected, by impedance, not needing exterior protection
- synchronous motor with E.C.M. (Electronically Commuted Motor) technology fitted with a permanent-magnet rotor. The rotating magne-tic field of the stator is engendered by the coils being electronically switched.
This rotating field creates a continuous torque by attraction of the opposite magnetic poles of the rotor, thus controlling its position (synchronous motor). This gives the motor optimum perfor-mance, whatever its speed.
Protection class: IP 44Max. temperature of the fluid being pumped : TF 110CEM compliance : - emission 61000-6-3 - immunity 61000-6-2
IDENTIFICATIONCELCIUX
Circulating pump for domestic systemsBronze Body H max : 5 mND 25 - Centre distance: 180 mm
BASIC CONSTRUCTIONMain components MaterialPump casing BronzeImpeller CompositeShaft and can Stainless steelImpeller joint ring Stainless steelBearings GraphiteWaterproof gasket Ethylene-propylene
HYDRAULIC PERFORMANCES
SETTINGSALL SETTINGS ON JUST ONE BUTTON
The selector button on the front of the termi-nal box selects the hydraulic curve to suit the needs of the installation.The figures from 1 to 5 show the manometric head.All the intermediate positions are possible for meet the needs of any installation.
• Fast and easy to install
Electrical connexions can be made on either side of the terminal box.
The flat on the body of the pump means you can hold it with a spanner while installing it
Fast electrical
connexions
INSTALLATION
ENERGY-SAVINGHigh performance circulating pumps, with optimisation of the point of operation.Up to 80 energy-saving compared with a tra-ditional circulating pump.
2
CELCIUX
CROSS-SECTION
Domestic hot water distribution system:• Maximum temperature of the system 60°C (according to D.T.U) and up to 80°C for steri-lisation purposes.
• Recommended speed of flow between 0.5 and 1 m/s max.
• Circulating pump mounted on the return pipe, after the taps.
INSTALLATION DIAGRAM
Heating pump
Boiler Mains water
Safety unit
Shut-off valve Non-return valve
Hot Water Circuit
Heating return pipe
Hot water distribution point
Prép
arat
eur E
.C.S
.
CELCIUX
Anti-particle filter
Pierced shaft
3
CELCIUX
G1"1/2128 mm
61 mm 67 mm
93,5 mm 34,1 mm96 mm
78 mm50,5 mm
73,5
mm
90 m
m18
0 m
m
Référencecommande
MOTEUR POMPE
Vitesse (Tr/min) P1 (W) I1 (A)Entraxe
Raccordement sur tube fileté Masse(kg)Min Max Min Max Min Max Ø 3/4” Ø 1“
CELCIUX 1 400 3 500 5,8 59 0,07 0,46 180 mm RED 2027ref 4016195
RU 2634ref 4016173 2,9
ELECTRICAL FEATURES AND SIZES SPECIAL FEATURESa) Electrical- Monophase 230 V - 50 Hz (60Hz) with condenser built into the terminal box.
- Motor protected by circuit-breaker – not essential.
b) Fitting- Motor shaft always horizontal.- Connected to the installation by pipe unions.
c) Packaging- Delivered with joints, without pipe unions.
d) Maintenance- Appliance automatically exchanged.
FITTING POSITIONS
• Shut-off ball valveRU 2634 - Réf.: 4063825
ACCESSORIES
• Adaptor rings ØG 1”1/2 - 2”Ref.: 4051850
• Pipe union
If you want information on the CELCIUX with centralised technical management system, please contact us.
Order Reference
MOTOR PUMP
Speed (Tr/min) P1 (W) I1 (A)Entraxe
Connecting on threaded pipe Mass(kg)Ø 3/4” Ø 1”
4
top related