2004 murano - scosche · nissan 2004 murano images radio speaker front speaker rear 1. remove screw...

+12V Constant =

+12v Acc. Switched =

-12V Chassis Ground =

+12V Illumination =

+12V Dimmer =

Amp Remote =

LF+ =

LF- =

RF+ =

RF- =

LR+ =

LR- =

RR+=

Dash Type :

Kit:Harness:Antenna Adapter: NDA-1

Interface Adapter(s): N/A

About the Vehicle

Make: NISSAN

Model: MURANO

Year: 2004

In Dash Application

Wire Color Codes

Speaker Notes

Front Speaker Sizes

Speaker Adapter : N/A

Factory Assembly : Plastic housing with (3) PHS Screws .

Rear

MURANONISSAN

2004

Photo by Scott Jacobs

DOUBLE DIN

TBA

NN03

RR- =

Factory Assembly : Plastic housing with (3) PHS Screws

NOTES

Upper Dash: 1 1/4" Tweeter

Speaker Sizes

Dimensions:

There is 5 1/4'' sub in some models, which is located in the spare tire wheel well.

Dimensions: Rear Deck W= 5 1/4'' D= 3 3/4'' L = 5 1/4''

NOTES

Lower Door : 6 1/2"Midbass

OPTIONS

BOSE System(7 Speaker)6 Disc ChangerDVD ONSTARSUBWOOFER

AMPLIFIER LOCATIONS: Located behind the right rear seat.

Aftermarket Kit: SINGLE DIN

W= 5 1/4''D= 3 3/4''L= 5 1/4''

Lower Door: 6 1/2'' Midrange

NISSAN2004 MURANO

Images

Radio speaker

Front speaker

Rear

1. Remove screw cover by the door handle and remove the screw.2. Remove the cover around the door handle. Remove screw from upper door handle.3. Remove the screw cover from just behind the window switch. Remove the screw and pry out the window switch assembly. Disconnect and remove.4. Remove one screw from the inner door handle.5. Using a panel removal tool pry off the door panel. Disconnect and remove.6. Remove (3) screws from the speaker. Disconnect and remove

1. Remove screw cover by the door handle and remove the screw.2. Remove the cover around the door handle. Remove screw from upper door handle.3. Remove the screw cover from just behind the window switch. Remove the screw and pry out the window switch assembly. Disconnect and remove.4. Using a panel removal tool pry off the door panel. Disconnect and remove.5. Remove (3) screws from the speaker. Disconnect and remove

Radio removal

Front speaker

Rear speaker

1. Using a panel removal tool pop out left and right panels on the sides of the radio console2. Using a panel removal tool pop up the bottom portion of navigation panel to acess (2) Philips screws. *NOTE* DO NOT remove the navigation panel.3. Remone (2) screws from the top radio portion of the dash.4. Remove (4) screws from the sides of the radio. Disconnect and remove.

1. Using a panel removal tool pry up the grille over the dash tweeter.2. Remove (2) screws from tweeter. Disconnect and remove.

Front Dash