• Always unplug the router before changing router bits.•Inspect all bits before installing into the router. Ensure the bit is clean and has no chipped pieces.•When installing a bit, drop it all the way into the router's cullet, then back it out about 1/16" to 1/8" to avoid transferring the heat generated by the bit directly to your router's motor armature. Be sure the cullet is tightened adequately. •Be certain the router motor switch is turned to the “OFF” position before plugging the router into an electrical outlet.•Have a firm grip on the router before turning it on. Remember, you're holding between 1hp and 3hp of power in your hands. When you turn on the power, the torque of the motor will try to pull the router out of your hands. Be aware of this and be prepared. •If you're using a router table, be certain the table is securely clamped to the bench top or its support legs before starting work.

• Be sure of which direction to push the wood through the router.

•Keep fingers clear of the bit.

•Be sure not to press the wood hard against the bit it can cause a burning smell, and may start a fire.

• Keep your router station clear of sawdust before and after use of router.

•Wear proper eye protection & secure loose clothing and jewelry.

•The router is used to cut a dado.•The router also helps put a more stylish border on the wood and sometimes can even be used to engrave things such as pictures and words into the wood. Only hand routers can do this, table routers are restricted to borders.

RoutedUnrouted

•Click on the photo for a demonstration on the proper way to operate a router

correctly.