Cedarbrook   Sauna   + Steam– Family   owned   and   operated   since   1971

We build cedar saunas , kits, sauna doors , accessories for commercial saunas & residential sauna

rooms — AND we have the expertise to fit you with the right sauna heaters , steam room doors and steam room equipment.

If you are ever in the Seattle area, we have a showroom just northeast of the city where you'll find

sauna and steam rooms plus accessories on display.

If you have any questions regarding saunas and steam rooms, we’re your resource!

Sweating the details since 1971

Brekke LysakerManagement

r friendly staff is ready to answer your questions on what we do best : building and designing sauna rooms and doors, selecting the sauna heater that best fits your needs and answering any other questions regarding sauna and steam rooms.

Ou Cedarbrook Sauna + Steamhttp://cedarbrooksauna.cominfo@cedarbrooksauna.com1.800.426.3929

“Almost Assembled” Adirondack Assembly Instructions Standard Chair & Love Seat

Unpack and examine all parts which consist of:

Standard Adirondack Chair: 1 each: seat section 1 each: back assembly section 2 each: front legs with brackets mounted

2 each: back section angle supports (approx. 24" in length) with arm support brackets mounted

2 each: arms 1 each: hardware kit (includes TiteBond III glue,

square drive bit and applicable stainless steel hardware)

How to Assembly the Standard Adirondack Chair

1. Assemble two (2) front legs to seat section utilizing glue, carriage bolts, nuts and washers. Brackets on legs are to be to the outside of the seat section. Screw two (2) No. 8 X 1-3/4” ss screws from inside of seat section in pre-drilled holes for additional support.

2. Apply glue to notched area on seat base assembly and attach back assembly to seat base using No. 8 X1-3/4” ss screws in pre-drilled holes. Use a clamp to hold in place while inserting screws.

Note: IF assembling the Love Seat, use glue and one No. 8x1-3/4” screw to secure to middle leg support.

Place glue between leg

and seat base prior to

attachment

Apply glue to notched

area on seat base before attaching seat back assembly

3. Apply glue and screw angle bracket assemblies into the middle back slat support through pre-drilled holes using No. 8 X 1-3/4” ss screws. Apply glue and connect bottom of back angle assemblies to seat base assembly using No. 8 X 1-3/4” ss screws through pre drilled holes. Note: bracket mounted to angle bracket assemblies should be facing out, away from chair.

4. Apply glue to rear edge of arm and mount into back section angle supports through pre-drilled holes using No. 8 X 1-3/4” ss screws. Then position front of arm over front leg and arm support brackets, apply glue and mount from underneath through arm support bracket using No. 8 X 1-3/4” ss screws.

Apply glue prior to

assembly

Apply glue to rear edge of arm prior to attaching

to back section angle

support

Apply glue on top of front arm

support and front leg prior to

attaching arm

5. Let glue dry, do any final “touch up” sanding deemed necessary

and your L.R. Woodworking Standard Adirondack Chair is ready for a lifetime of use! If you have any problems with assembly, call 281-

813-1169 for assistance.

We appreciate your business!