Page 1

9' X 27' EVENT TENTASSEMBLY INSTRUCTIONS

DESCRIPTION ITEM #SPORTCRAFT EVENT TENT 9’ X 27’ - 8 LEG - WHITE 180-06838420-5

Please read instructions COMPLETELY before assembly. This tent MUST be securely anchored. THIS IS A TEMPORARY STRUCTURE AND NOT RECOMMENDED AS A PERMANENT STRUCTURE.

HELPFUL TOOLS

Page 2

CAUTION:

Prior to installation, choose the location of your tent carefully. DANGER: Keep away from electrical wires. Check for overhead utility lines, tree branches or other structures. Check for underground pipes or wires before you dig. DO NOT install near roof lines or other structures that could shed debris onto your shelter. DO NOT hang objects from the roof or support cables.

DANGER:

Use CAUTION when erecting the frame. Use safety goggles during installation.

A tight cover ensures longer life and performance. Always maintain a tight cover. Loose fabric can acceler-ate deterioration of cover fabric. Immediately remove any accumulated debris from the roof structure with a broom, mop or other soft-sided instrument. Use extreme caution when removing debris from cover- always remove from outside the structure. DO NOT use hard-edged tools or instruments like rakes or shovels to remove debris. This could result in punctures to the cover. DO NOT use bleach or harsh abrasive products to clean the fabric cover. Cover is easily cleaned with mild soap and water.

CARE AND CLEANING:

9' x 27' SPORTCRAFT EVENT TENT - 8 Leg - Parts List

1. LAYOUT ALL PIECES OF FRAME ON GROUND

Note: approximate set up time with 2 people is 30-45 minutes (minimum 2 people recommended).

4 pcs

10 pcs6 pcs

5 pcs

3 pcs

8 pcs

8 pcs

16 pcs

2 pcs

4 pcs 4 pcs 2 pcs 2 pcs 8 pcs 8 pcs 16 pcs

Risk of fire. DO NOT smoke or use open flame devices (including grills, fire pits, deep fryers, smokers or lanterns) in or around the tent. DO NOT store flammable liquids (gasoline, kerosene, propane, etc.) in or around your tent. Do not expose top or sides of the tent to open fire or other flame source.

WARNING:KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of CPAI-84. The fabric may burn if left in continuous contact with any flame source.

DO NOT leave your tent set-up for days at a time. Be aware that exposure to ultraviolet rays from the sun can seriously damage material.This product is not intended to be used during heavy rain, wind, hail, snow or other inclement weather. Excess water build-up can cause the frame system to become unstable, and possibly collapse, causing injury.

2. ASSEMBLE ROOF FRAME & UPPER PORTION OF LEG FRAME

3. PLACE THE COVER ON TOP AND SECURE TO THE ROOF FRAME WITH VELCRO STRAPS

Please push frame together firmly at all joints. Joints are tight-fitting.4. ATTACH THE LOWER PORTION OF LEG FRAME TO THE UPPER PORTION OF LEG FRAME

Leg Pole Assembly

5. ATTACH THE SIDE PANELS TO THE ROOF FRAME & SECURE WITH VELCRO STRAPS

7. USE THE GUY ROPES AND ANCHORS TO SECURE THE TENT

6. ANCHOR THE FRAMEAttach base feet to each pole.There are four holes on each base foot that the anchor can go into.Select a hole in each base foot. Insert each anchor into the ground until the round head is touching the base foot. These anchors prevent the canopy from shifting. Insert one anchor into all four base feet.Additional anchors(purchase separately) can add stability.

Anchoring Base Feet

CUSTOMER SERVICE INFORMATION If you have any questions please contact us at:

Phone: 1-866-283-4412 Email: customerservice@t2products.comMail address: 144 Talbert Pointe Dr., Suite 103

Mooresville, NC 28117

Helpful Hint: For ease of assembly, add the 4 lower leg frame portions to one side and then proceed to the other side to complete assembly.

Page 3 Page 4

1

2

3