60 seconds voice recoder
TRANSCRIPT
-
7/27/2019 60 Seconds Voice Recoder
1/12
60 SECONDS VOICE RECODER
Under the guidance of
Ms. KOWSAR YASMEEN
Submitted by
M.RAMYA KRISHNA
(085K1AO429)
B.MALLIKA
(085K1A0420)
-
7/27/2019 60 Seconds Voice Recoder
2/12
ABSTRACT
The main intention of this project 60 seconds voice recorder isto record and playback the voice signals up to 60 seconds using
APR9600 IC chip.
The APR9600 is a good standalone voice recorder or playback IC
with nonvolatile storage and playback capability for 32 to 60seconds.
It can record and play multiple messages at random or insequential mode.
In this project we useRandom access mode
.Random accessmode supports2, 4 or 8messages of fixed duration.
The maximum length of the 8 sound tracks is 7.5seconds each.
-
7/27/2019 60 Seconds Voice Recoder
3/12
INTRODUCTION
Sample rates are user-selectable, allowing designers tocustomize their design for unique quality and storagetime needs.
The device is ideal for use in portable voice recorders,toys, and many other consumer and industrialapplications.
This technology enables the APR9600 device to
reproduce voice signals in their natural form.
-
7/27/2019 60 Seconds Voice Recoder
4/12
CIRCUIT DIAGRAM
-
7/27/2019 60 Seconds Voice Recoder
5/12
FUNCTIONAL DESCIPTION
Complete chipmanagement isaccomplished through thedevice control and messagecontrol blocks.
At the left hand side of thediagram are the analoginputs.
Recording can be feddirectly into the ANA_IN
pin through a DC blockingcapacitor. The signal can be heard by
connecting a speaker to theSP+ and SP- pins.
-
7/27/2019 60 Seconds Voice Recoder
6/12
RANDOM ACCESS MODE
As mentioned earlier, the random-access modesupports 2,4,or 8 messages of fixed durations.
The length of each message is total recording lengthavailable divided by total number of memorysegments.
-
7/27/2019 60 Seconds Voice Recoder
7/12
RECORDING OF SOUND
Pins 9,24 and 25 are pulled high through resistor R9respectively.
when switch s9 is closed, record pin27 goes low toenable recoding of the message from the microphone.
PLAYBACK OF SOUND TRACKS
open switch s9 to make pin 27 high while keepingother switches in the same positions as in recording.
-
7/27/2019 60 Seconds Voice Recoder
8/12
APPLICATIONS
Doorbell or entrance message. Greet your guests orcustomers with a welcome message.
Watchdog" burglar alarm system. Record the barking of
a dog and connect this circuit to a alarm system to deterburglars.
Toys applications where you need speech or audioeffects.
Talking picture frames for personal or museum use. Addit to the back of a picture frame of a friend or relative tohave his or her voice be played back at any time.
-
7/27/2019 60 Seconds Voice Recoder
9/12
ADVANTAGES
Single-chip, high-quality voice recording &Playbacksolution No external ICs required
Minimum external components
Non-volatile Flash memory technology No battery backup required
User-selectable messaging options Random access of multiple fixed-duration messages
Sequential access of multiple variable duration Message.
DISADVANTAGES By this we can record up to 60 seconds only.
By using 8 push buttons the circuit becomes complex.
-
7/27/2019 60 Seconds Voice Recoder
10/12
CONCLUSION
The range of message recorder kit can be used to storevoice messages or sound clips and effects etc, .in factjust about any noise you want to capture and replay. Ithas re-recordable nonvolatile memory. Which meansthe message will be stored even after the units areturned off and back on again.
-
7/27/2019 60 Seconds Voice Recoder
11/12
FUTURE SCOPE
With the APR9600 we can record and playback upto 60 seconds only. But with the advanced digital
audio record player you can record more can 60seconds of speech with the built in microphoneand later play it back any time.
This unique design is made possible through the
ISD2XX series of integrated circuits which storesvoice and audio signals directly.
-
7/27/2019 60 Seconds Voice Recoder
12/12
THANK YOU