500 & 300mm pull out larder hyh1315/1316...500 & 300mm pull out larder hd148051 hyh1315v2...
TRANSCRIPT
IMPORTANT: Ensure the cabinet is level, plumb and secured to the wall before installing this product.Follow the installation manual for fixing the feet to your cabinet.Note: The 500 larder unit should have 5 feet fitted (one in a front centre position for extra stability as shown in stage 1).
500 & 300mm Pull Out Larder
HD148051 HYH1315v2
Assembly
1
3
HYH1315/1316
Using the dimensions shown spikerunner fixing positions
Fit the base runner plate to the bottom of the frame‘clicking’ into place to lock.
Note: Make sure the dimensionsare accurately spiked.
2
Screw x3(4.5x16mm csk)
Part 1Base Runner
Case x1
Part 2Base RunnerCentral Plate x1
Top Runner x1
TopRunnerFixingHoles
251mm
59mm91mm
Top Panel
= =
32mm
500 larderadditional foot
Base Panel
= =
Screw x8(4.5x16mm csk)
Important Notes:
Do not use a power driver for this product installation18kg maximum load per basket
Ensure packaging is disposed of in a safe environmentally friendly wayWe recommend the larder door handle is fitted horizontally
For five piece door constructions , care should be taken when fixing screws through into the back of the doorIntegrated handle ranges require a longer door strap & a centre bracket supplied in the additional pack (see stage 4)
The Pull-Out runners will require adjusting once baskets are loaded, as weight distribution will affect the closing action
Frame x1Clickto lock
Base Runnerplate x1
Note: The Base runner is supplied assembled and consists of three parts:Part 1 - Base Runner Case, Part 2 - Base Runner Central Plate, Part 3 - Base Runner Plate.The base runner plate (Part 3) will need to be removed before fitting the base runnercase (Part 1) to the cabinet. The central plate (Part 2) can be left in position as shown above.
32mm
384mm
480mm448mm
HD148051
Assembly
Adjustment
4
Loosen inner screws before adjustment making sure they are re-tightened once adjustment is completed. Note: Further adjustment may be required once baskets are loaded. Screws fitted in stage 7 will need to be removed before adjustment can be made.
ReleasingDoor
ReleasingRunner
Door tiltUp/Down
Left/Right Door Angle
IMPORTANT: For 5 piece door constructions and Integrated handle doors, do not place fixing screws through the frame and into the thin section of the door/handle section.
425mm
= = = =
1804mm
1804mm2mm
5
7
8
Repeat this stagefor all five baskets
Fit frame to frontal assembly aligning the bracket.
*For integrated handleranges use a longer doorstraps & centre bracket suppliedin the additional pack
Lift the front clip carefullyto release
Push the green buttonto release and pull out
2 per bracket (300 Unit)4 per bracket (500 Unit)Note: Be aware of handle screw
positions when fixing the door straps
Note: The two central screws in the topbracket should not be fitted whenfitting a 5 piece door, with athin centre panel
6 Fit the frame to therunners
225mm
500 Frontal 300 Frontal
Screw x8(4.5x16mm csk)
Screw x8(4.5x16mm csk)
TOP 1.2.
CLICKTOLOCK
CLICKTOLOCK
A
1.
2.
3.
B
C D
Screw x4(4x35mm)
Door Bracket x2
*DoorStrap x2
=
69mm
1.
2.
3.
69mm
2mm