3m qt-i - qt-ii - qt-iii features
TRANSCRIPT
Page 1 of 2
3M QT-I, QT-II and QT-III Termination Feature & Benefit Comparison
Product Feature 3M QT-I 3M QT-II 3M QT-III Customer Benefits
Living Seal - expands & contracts with cable as
energized and outside temperature changes
No Flame Torch needed
Constant radial pressure
Easy to install for Contract or In-House Crews
Eliminates air voids between Hi-Dielectric Constant
Stress Contol tube and cable insulation
3M is Inventor of Cold Shrink, and has 40 years
experience perfecting it.
Easy to install Termination in limited space
Can start termination and adjust to perfect position
before fiinishing pulling out core
Easy pulling of core over larger diameter shield
end of prepped cable
Termination and stress control not required to
shrink as far over cable insulation and semicon
Entire termination on the core - no need to fold
down bottom shield cover as on Tyco TFT and
Elastimold Ranger-2
Red Shipping Core No No YesStrong support for white pull core under
Termination & Mastic during shipping and storage
Don't need to apply separately
Is factory installed in the right position, reducing
cable installation errors
Helps reduce voltage stress at semicon step
Don't need to apply grease by hand
Is factory installed in the right position, reducing
cable installation errors
Blocks moisture from getting into termination
around the lug barrel
Don't need to wrap tape around top of termination
Is factory installed in the right position, reducing
cable installation errors
English Instructions
included with each kitYes Yes Yes Eliminates installation questions at the job site.
Lugs or stem
connectors can be
included in the kits
Yes Yes Yes Complete Work Package for your crews
IEEE-48 / Cenelec 0278
/ IEC 502 Tested
On going for
Cenelec / IECYes Yes Reliability tested in a Lab
Over 1 million installed No - New productYes - Over 10
million installedYes Customer Proof of Reliability in the field
Arc and Track
Resistance Test ASTM
2303 @ 3.5kV &
IEC 60 587
Test on-going
integrated skirts
1.2 Hours
integrated skirts
5.0 Hours
integrated skirtsLong service life
Silicone Body for
Excellent UV
Resistance
Yes Yes Yes Long service life
Installation
Technology
Push-on
5kV - 36kV
Cold Shrink
5kV - 46kV
Cold Shrink
5kV - 35kV
and 69kV
Pull Core No Yes Yes
Step Core No Yes Yes
Stress Control built
into Termination
Yes
(integrated -
molded in silicone
insulator)
Yes
(integrated -
separate part)
Yes
(integrated -
separate part)
Semicon Filler Hi-K
Mastic built into
Termination
No - Semicon step
filling grease
applied by hand
No - Semicon step
filling grease
applied by hand
Yes
Top Seal Mastic built
into Termination
No - Kits contain
#70 Silicone Tape
to be hand applied
or slide on silicon
tube
No - Kits contain
#70 Silicone Tape
to be hand applied
Yes
Page 2 of 2
Product Feature 3M QT-I 3M QT-II 3M QT-III Customer Benefits
Transfer Cost (Euro/kit)
Outdoor 24kV30 40 60 Price per 3 phase kit without lugs