C:My documents\salesofficeandrew\Holden Rodeo TF Tray.

Revision 1 – 04/05/10

This is an Uncontrolled document.

26814.7

L.P. GAS CYLINDER

INSTALLATION INSTRUCTIONS

HOLDEN RODEO / ISUZU

TF SERIES 1988 – 2003

2WD/4WD TRAY BACK UTILITIES

This Automotive LP Gas cylinder must be installed in the vehicle in strict accordance with the latest

requirements of AS/NZS1425. Any modifications to the cylinder will render the warranty null and void.

General Cylinder Specifications:

DIAMETER : 375mm LENGTH : 760mm

WATER CAPACITY: 75L L.P GAS CAPACITY : 60L

VALVE ORIENTATION : 30 degrees

Vehicle Modifications:

• Relocate Spare wheel

• Modify exhaust Tail Pipe.

(Stone Shield and Exhaust Heat Shield supplied).

Installation:

1. This cylinder is designed to be mounted 2. Depending on the style of tray, the RH

at the rear of the vehicle behind the differential. tray mounting bracket may need to be

Remove the spare wheel and relocate it. removed to fit the cylinder in place. Retain this

Remove the exhaust Tail Pipe. bracket as it will be refitted later.

C:My documents\salesofficeandrew\Holden Rodeo TF Tray.

Revision 1 – 04/05/10

This is an Uncontrolled document.

3. Jack the cylinder into position. 4. The mounting bracket on the right hand side

is to fit on top of the chassis as shown, in between

the rear shock absorber mount and the tray

mount.

5. The mounting bracket on the left hand side is 6. Using the U-bolts supplied, bolt the right

to fit underneath the chassis. Note how the side of the cylinder to the chassis as shown.

cylinder mounting bracket is bent to follow

the contour of the chassis.

7. Bolt the left side of the cylinder to the chassis 8. Check the cylinder is not touching the vehicle

incorporating the exhaust heat sheild as shown. at any point. Connect the cylinder in accordance

with AS1425. Refit the tray mounting bracket.