2012 toyota highlander bluetooth

347

3

Interior features

3-3. Using the Bluetooth® audio system

Bluetooth® audio system∗

■Conditions under which the system will not operate● If using a portable player that does not support Bluetooth®

● If the portable player is switched off

● If the portable player is not connected

● If the portable player’s battery is low

● If the portable player is behind the seat or in the glove box or console box

● If metal is covering or touching the portable player

The Bluetooth® audio system enables you to enjoy music played ona portable digital audio player (portable player) from the vehiclespeakers via wireless communication.

This audio system supports Bluetooth®, a wireless data systemcapable of playing portable audio music without cables. If your por-table player does not support Bluetooth®, the Bluetooth® audio sys-tem will not function.

Owners of models equipped with a navigation system should refer tothe “Navigation System Owner's Manual”.

Title Page

Using the Bluetooth® audio system P. 350

Operating a Bluetooth® enabled portable player P. 355

Setting up a Bluetooth® enabled portable player P. 357

Bluetooth® audio system setup P. 362

∗: If equipped

jrubino

Stamp

348


■When transferring ownership of the vehicleBe sure to initialize the system to prevent personal data from being improp-erly accessed. (→P. 387)

■About Bluetooth®

■Compatible models●Bluetooth® specifications:

Ver. 1.2

●Following Profiles:

• A2DP (Advanced Audio Distribution Profile) Ver. 1.0• AVRCP (Audio/Video Remote Control Profile) Ver. 1.0 or higher (Ver.

1.3 or higher recommended)Portable players must correspond to the above specifications in order to beconnected to the Bluetooth® audio system. However, please note that somefunctions may be limited depending on the type of portable player.

■Certification for the Bluetooth® audio systemFCC ID: ACJ932C5ZZZ035IC ID: 216J-C5ZZZ035MADE IN JAPAN

This device complies with Part 15 of the FCC Rules and RSS-Gen of ICRules. Operation is subject to the following two conditions: (1) this devicemay not cause harmful interference, and (2) this device must accept anyinterference received, including interference that may cause undesired oper-ation.

Bluetooth is a registered trademark ofBluetooth SIG. Inc.

349


3

Interior features

CAUTION

■FCC WARNINGChanges or modifications not expressly approved by the party responsiblefor compliance could void the user's authority to operate the equipment.

Radio Frequency Radiation Exposure. This equipment complies with FCC/IC radiation exposure limits set forth for uncontrolled equipment and meetsthe FCC radio frequency (RF) Exposure Guidelines in Supplement C toOET65 and RSS-102 of the IC radio frequency (RF) Exposure rules. Thisequipment has very low levels of RF energy that it deemed to comply with-out maximum permissive exposure evaluation (MPE). But it is desirable thatit should be installed and operated with at least 7.9 in. (20 cm) and morebetween the radiator and person’s body (excluding extremities: hands,wrists, feet and ankles).

This transmitter must not be co-located or operated in conjunction with anyother antenna or transmitter.

■Caution while drivingDo not connect portable players or operate the controls.

NOTICE

■To prevent damage to portable playersDo not leave portable players in the vehicle. The temperature inside thevehicle may become high, resulting in damage to the player.

350


Using the Bluetooth® audio system

■ Audio unitDisplay Track title, Artist name,Album name, Elapsed time,“Streaming Audio”, etc. isdisplayed.Selects items such as menuand numberTurn: Selects an itemPress: Inputs the selecteditemBluetooth-Audio connec-tion condition

If “BT” is not displayed, theBluetooth® audio systemcannot be used.

■ Microphone

351


3

Interior features

Operating the system using voice commands

By following voice guidance instructions output from the speaker,voice commands enable the operation of the Bluetooth® audio sys-

tem without the need to check the display or operate .

■ Operation procedure when using voice commandsPress the talk switch and follow voice guidance instructions.

■ Auxiliary commands when using voice commandsThe following auxiliary commands can be used when operating thesystem using a voice command:

“Cancel”: Exits the Bluetooth® audio setup“Repeat”: Repeats the previous voice guidance instruction“Go back”: Returns to the previous procedure“Help”: Reads aloud the function summary if a help comment isregistered for the selected function

352


Using the Bluetooth® audio system for the first time

Before using the Bluetooth® audio system, it is necessary to registera Bluetooth® enabled portable player in the system. Follow the proce-dure below to register (pair) a portable player:

Press and hold until “BT AUDIO” is displayed.

Press (SETUP).

The introductory guidance and portable player name registrationinstructions are heard.

Select “Pair Audio Players (Pair audio player)” using a voice

command or .

Register a portable player name by either of the followingmethods:

a. Select “Record Name” using , and say the name to

be registered.b. Press the talk switch and say the name to be registered.

A voice guidance instruction to confirm the input is heard.

Select “Confirm” using a voice command or .

A passkey is displayed and heard, and a voice guidance instructionfor inputting the passkey into the portable player is heard.

STEP 1

STEP 2

STEP 3

STEP 4

STEP 5

353


3

Interior features

Input the passkey into the portable player.Refer to the manual that comes with the portable player for the oper-ation of the portable player.

Guidance for registration completion is heard.

If the portable player has a Bluetooth® phone, the phone can be reg-istered at the same time. (→P. 370)

Menu list of the Bluetooth® audio system

“BT Audio Setup” can be canceled by pressing the on-hook switch orsaying the voice command, “Cancel”.

First menu Second menu Third menu Operation details

Setup (Setup)

BT Audio Setup (BT audio setup)

Pair Audio Players (Pair audio player)

Registering a portable player

Select Audio Player

Selecting a portable player to be used

Change Name Changing the registered name of a portable player

List Audio Players

Listing the registered porta-ble players

Set Passkey Changing the passkey

Delete Audio Player

Deleting a registered porta-ble player

System Setup

Guidance Vol-ume

Setting voice guidance vol-ume

Device Name Displaying the Bluetooth® device address and name

Reset Setting Initializing the system

STEP 6

354


■When using a voice commandFor numbers, say a combination of single digits from zero to nine.

Say the command correctly and clearly.

■Situations where the system may not recognize your voice●When driving on rough roads

●When driving at high speeds

●When air is blowing out of the vents onto the microphone

●When the air conditioning fan emits a loud noise

■Operations that cannot be performed while driving

●Operating the system with

●Registering a portable player to the system

■Changing the passkey→P. 360

355


3

Interior features

Operating a Bluetooth® enabled portable player

Selecting an album

Press “∨” or “∧” on .

Selecting tracks

Press “∧” or “∨” on .

Playing and pausing tracks

Press .

VolumePower

Playback/pause

Displaying text messages

Selector knob

Selecting tracksFast-forwardingand reversing

Playback

356


Fast-forwarding and reversing tracks

Press and hold “∧” or “∨” on .

Switching the display

Press .

Each time is pressed, the display changes in the following order: Track title → Track title/Artist name → Track title/Album name → Tracktitle/Elapsed time

Using the steering wheel audio switches

→P. 341

■Bluetooth® audio system functionsDepending on the portable player that is connected to the system, certainfunctions may not be available.

357


3

Interior features

Setting up a Bluetooth® enabled portable player

Registering a portable player in the Bluetooth® audio system allowsthe system to function. The following functions can be used for reg-istered portable players:

■ Functions and operation procedures

Press and hold until “BT AUDIO” is displayed.

Press (SETUP).

Select one of the following functions using a voice com-

mand or .

● Registering a portable player “Pair Audio Players (Pair audio player)”

● Selecting a portable player to be used “Select Audio Player”

● Changing the registered name of a portable player“Change Name”

● Listing the registered portable players “List Audio Players”

● Changing the passkey “Set Passkey”

● Deleting a registered portable player “Delete Audio Player”

STEP 1

STEP 2

STEP 3

358


Registering a portable player

Select “Pair Audio Players (Pair audio player)” using a voice com-

mand or , and perform the procedure for registering a portable

player. (→P. 352)

Selecting a portable player to be used

Select “Select Audio Player” using a voice command or

.

Select the portable player to be used by either of the followingmethods, and select “Confirm” using a voice command or

:

a. Press the talk switch and say the name of the desired por-table player.

b. Press the talk switch and say “List audio players”. When thename of the desired portable player is read aloud, press thetalk switch.

STEP 1

STEP 2

359


3

Interior features

Press the talk switch and say “From car” or “From audio”, and

select “Confirm” using a voice command or .

Vehicles with smart key system: If “From car” is selected, the porta-ble player will be automatically connected whenever the “ENGINESTART STOP” switch is in either ACCESSORY or IGNITION ONmode.

Vehicles without smart key system: If “From car” is selected, the por-table player will be automatically connected whenever the engineswitch is in either the “ACC” or “ON” position.

Changing the registered name of a portable player

Select “Change Name” using a voice command or .

Select the name of the portable player to be changed byeither of the following methods, and select “Confirm” using a

voice command or :



Press the talk switch or select “Record Name” using ,

and say the new name.


STEP 3

STEP 1

STEP 2

STEP 3

STEP 4

360


Listing the registered portable players

Select “List Audio Players” using a voice command or . The

list of registered portable players will be read aloud.When listing is complete, the system returns to “BT Audio Setup”.

Pressing the talk switch while the name of a portable player is beingread aloud selects the portable player, and the following functions willbecome available:

● Selecting a portable player: “Select Audio Player”

● Changing a registered name: “Change Name”

● Deleting a portable player: “Delete Audio Player”

Changing the passkey

Select “Set Passkey” using a voice command or .

Press the talk switch, say a 4 to 8-digit number, and select

“Confirm” using a voice command or .

When the entire number to be registered as a passkey has

been input, press again.

STEP 1

STEP 2

STEP 3

361


3

Interior features

Deleting a registered portable player

Select “Delete Audio Player” using a voice command or

.

Select the portable player to be deleted by either of the follow-ing methods and select “Confirm” using a voice command or

:



If the portable player to be deleted is paired as a Bluetooth® phone,the registration of the mobile phone can be deleted at the same time.A voice guidance instruction to delete a mobile phone is heard.


■The number of portable players that can be registeredUp to 2 portable players can be registered in the system.

STEP 1

STEP 2

STEP 3

362


Bluetooth® audio system setup

■ System setup items and operation procedures→P. 385

2012 toyota highlander bluetooth

Automotive