2008 bmw r1200s - power commander 2008 bmw r1200s- 1 2008 bmw r1200s installation instructions...
TRANSCRIPT
i950-411 www.powercommander.com 2008 BMW R1200S- 1
2008 BMW R1200SInstallation Instructions
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com
Parts List1 Power Commander1 USB Cable1 CD-ROM1 Installation Guide1 Power Adapter2 Power Commander Decals2 Dynojet Decals2 Velcro® Strip1 Alcohol Swab
You can also download the PowerCommander software and latest mapsfrom our web site at:
www.powercommander.com
The ignition MUST be turnedOFF before installation!
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Button Adjustment Display
Faceplate Buttons
USB PortExpansion Port
1 Remove the main seat.2 Lay the PCIII under the seat area
temporarily.3 Unplug the stock wiring harness from
the right hand side injector (Fig. A).
5 Unplug the stock wiring harness fromthe left hand side injector (Fig. C).
6 Unplug the stock wiring harness fromthe Throttle Position Sensor (Fig. C).
Fig
. A
Fig
. B
i950-411 www.powercommander.com 2008 BMW R1200S- 2
4 Plug the YELLOW colored wiresfrom the PCIII in-line of the righthand side injector and stock wiringharness (Fig. B).
Fig
. C
Stock connector
Unplug
Unplug
PCIII connectors
DO NOT TURN ON THE IGNITION WHILEANY CONNECTIONS ARE
UNPLUGGED
10 Attach the ground wire of the PCIII tothe negative side of the battery. MAKE SURE YOU HAVE A GOODGROUND BEFORE TURNING ONIGNITION.
Fig
. E
7 Route the PCIII harness behind theintake tube.
8 Plug the PCIII harness in-line of thestock injector and wiring.
9 Plug the PCIII harness in-line of thestock TPS and wiring harness (Fig. D)
Fig
. D
i950-411 www.powercommander.com 2008 BMW R1200S- 3
11 Install the PCIII in the area under themain seat. You can use the suppliedvelcro or zip ties to secure the unitdepending on your setup.Fi
g.
F
Ground wire
12 Unplug the stock O2 sensor from themain wiring harness on the left handside (Fig. G).This connector is located near thelower ignition coil.
13 Unplug the stock O2 sensor from themain wiring harness on the right handside (Fig. H).This connector is located near thelower ignition coil.The stock O2 sensors will no longerbe connected to anything. They canbe removed completely from theexhaust if desired.
14 Make sure all connections are secureand reinstall seat.
Fig
. G
Fig
. H
i950-411 www.powercommander.com 2008 BMW R1200S- 4
Unplug O2 sensor
Unplug O2 sensor