2008-09 chrysler 300 ae page 1 - scoschemygig hard drive based multi media source unit 3.5mm aux/usb...
TRANSCRIPT
+12v Constant = Gray/Green +12v Acc. Switch = CanBus DATA -12v Chassis Ground= Black/Green +12v Illumination = CanBus DATA +12v Dimmer = CanBus DATAAntenna/Amp Remote = CanBus DATA Can-Bus = White & White/Orange
LF+ = Gray/PurpleLF- = Gray/Yellow
RF+ = Green/Purple RF- = Green/Yellow LR+ = Green/Orange LR- = Green/Gray RR+ = Green/Black RR- = Yellow/Gray
Dash Type : Double DINAftermarket: Single/Double DINKit: CR1288B/CR1291BHarness: CR06SRAntenna Adapter: VWA3B/VWA3RB
elciheV eht tuobA
Make: ChryslerModel: 300Year: 2008-10
noitacilppA hsaD nI
sedoC roloC eriW
setoN rekaepS
Front Speaker Sizes
Rear
Chrysler 300
NOTES
Dimensions: Front Dash
Dimensions:W= 5.75'' L= 8.5'' D=
NOTES
Standard/OptionalCD Player6 Speaker 288-watt Boston Acoustics StereoIn-dash CD changerNavigation System 7 Speaker 380-watt stereoMyGig Hard Drive Based Multi Media Source Unit 3.5mm AUX/USB Port/iPod Connectivity
On the left side of the steering column. W= 4.25'' L= 4.25'' D= 2.5''
Type: Standard Audio System Location: At SpeakersSpeaker Sizes
Photo by Ford Motor Company
Front Dash: 3.5''Lower Door: 6x9”Speaker Adapter: SA69Speaker Harness: TBAFactory Assembly: (4) T-15 screws securing speaker.
Rear Deck: 6x9''Rear Deck: 8” SubwooferSpeaker Adapter: SA69Speaker Harness: TBAFactory Assembly: (4) 9/32” bolts securing speaker.
Dimensions: Lower DoorW= 5.75'' L= 8.5''D= 2.75”
2008-10
Chrysler 300
Images Radio Removal
Front Speakers
Rear Speakers
2. Extract (2) Screws securing speaker unplug and remove speaker
1. Using a panel removal tool to remove the dash speaker grille.
Radio
Recommended: Disconnect negative battery cable
Dash Speakers
Door Speakers
1. Use a pick tool to lift screw cover inside door release area and extract (1) screw from behind.
Rear Deck Speakers
1. Fold down rear seat sections.
1. Remove the rubber pad just in front of the shifter.Extract (2) PHS from underneath the pad.
2. Using a PRT remove the trim around the shifter.3. Using a PRT remove the whole trim panel that is
around the shifter that goes to the bottom of theash tray.
4. Using a PRT remove the ash tray trim panel.5. Using a PRT remove the trim around the radio
and A/C controls.6. Extract (4) PHS securing the radio to the dash.
Disconnect and remove.
Rear Subwoofer
2008-10
2. Use a pick tool to lift screw cover just below armrest and extract (1) screw from behind.3. Use a pick tool to to push in the pop-tab fasteners on outer rim of door panel. (1) Front, (2) on rear sill.4. Extract (4) Phillips head screws from lower door panel.5. Use a panel removal tool to pop off door panel, unplug and remove.6. Extract (4) Torx T-15 screws from speaker, unplug and remove.
2. Use a panel removal tool to pop out both rear “C” Pillar panels.3. Extract (1) 10mm bolt from each side bolster. Use a panel removal tool to release the upper part of the side bolsters and remove.4. Use a panel removal tool to pop out (1) pop panel fastener from the middle of the rear deck. 5. Remove rear deck tray by pulling up and out.
6. Extract (4) 9/32-7mm head screws from speaker, unplug and remove.
1. For premium-equipped vehicles with a Rear Deck Subwoofer, follow the “Rear Deck Speaker” removal steps.
Sub location
Rear Speakers
Door Speakers
Dash Speakers