2005 b2k assembly manual - vaporworks.net
TRANSCRIPT
1
2005 B2K Assembly Manual
Version 1.2
2
You will need:
• Set of Allen Keys and screwdrivers• Vice grips, presses, and assorted wrenches• Red Loctite• Blue Loctite• Lithium Grease• Teflon Tape
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
65
66
67
68
69
70
71
72
73
74
75
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
97
98
99
100
101
102
103
104
105
Testing Procedures• Screw in the barrel 402010 and make sure it threads in smoothly.• Connect battery to the terminal inside grip• Air up Marker with 850 psi gas
– Set High Pressure regulator to 250-300 psi– Turn on marker– Adjust low pressure regulator to about 90 psi by screwing in adjustment screw until
you hear a small leak coming from the back. Unscrew the screw ¼ turn.• Shoot marker and chrono at 280 fps.
– Look for irregularities in velocity or regulated pressure. If so, the marker is no good.
– Look and listen for leaks. If there are leaks, the marker is no good.– Shoot marker fast and make sure the bolt springs back and forth properly and does
not jam.– Verify that all parts are screwed on tight.– Make minor adjustments to trigger screws if necessary for contacting micro-switch.
106
Testing Procedures• Rest marker for a period and then start shooting again.
– Verify that the regulators do not climb or drop in pressure. If they do, marker is no good.
– Recheck for leaks• Turn off air supply and then re-apply gas.
– Make sure regulators climb back to previous set pressures and that they do not climb or drop. If they do, the marker is no good.
– Recheck for leaks– Verify chrono speed is still at 280 fps.
• If marker passes these test, it is satisfactory.– Disconnect battery and replace grip panel.– Clean outside of marker and inspect for good finish.– Unscrew barrel and package marker. Package should contain barrel, marker,
manual, and a kit containing 1 ¼ in. macroline elbow, 5 inches of hose, a H-010 UR o-ring, a 5/64 allen wrench, a 5/32 allen wrench, and a 3/32 allen wrench.