1. cut out 2. fold along all dashed lines(1).pdf1. cut out 2. fold along all dashed lines mountain...

4
1. Cut out 2. Fold along all dashed lines MOUNTAIN FOLD VALLEY FOLD 3. Glue tabs

Upload: others

Post on 10-Jul-2020

9 views

Category:

Documents


1 download

TRANSCRIPT

Page 1: 1. Cut out 2. Fold along all dashed lines(1).pdf1. Cut out 2. Fold along all dashed lines MOUNTAIN FOLD VALLEY FOLD 3. Glue tabs Cut out and glue dash with handlebars over the top

1. Cut out

2. Fold along all dashed lines

MOUNTAIN FOLD VALLEY FOLD

3. Glue tabs

Page 2: 1. Cut out 2. Fold along all dashed lines(1).pdf1. Cut out 2. Fold along all dashed lines MOUNTAIN FOLD VALLEY FOLD 3. Glue tabs Cut out and glue dash with handlebars over the top

1. Cut out

2. Fold along all dashed lines

MOUNTAIN FOLD VALLEY FOLD

3. Glue tabs

Cut out and glue dash with handlebarsover the top of the completed motorcycle.

Page 3: 1. Cut out 2. Fold along all dashed lines(1).pdf1. Cut out 2. Fold along all dashed lines MOUNTAIN FOLD VALLEY FOLD 3. Glue tabs Cut out and glue dash with handlebars over the top

1. Cut out

2. Fold along all dashed lines

MOUNTAIN FOLD VALLEY FOLD

3. Glue tabs

FRONT

Page 4: 1. Cut out 2. Fold along all dashed lines(1).pdf1. Cut out 2. Fold along all dashed lines MOUNTAIN FOLD VALLEY FOLD 3. Glue tabs Cut out and glue dash with handlebars over the top

1. Begin with the back wheel.

INSTRUCTIONS:

2. Attach the other side of the back wheel and connect the underside of the chassis.

3. Close up the front.

4. Glue the dash to the opposite side.

8. Assemble the front wheel.

9. Glue the front wheel onto the body. Make sure the tallest point of the front wheel is oriented towards the front of the motorcycle.

10. Attach the remaining accessories.

Glue the tab for the rear guard behind the tail light.

5. Glue down the windshield.

6. Carefully glue the first segment of the top panel to the body. Once it is firmly in place, connect the rest of one side.

7. Finish attaching the top to the other side.