1 alternator reference (1) b.l.thereja; chapter: 37 (2) rosenblatt; chapter: 19
TRANSCRIPT
1
Alternator
Reference (1) B.L.Thereja; Chapter: 37
(2) Rosenblatt; Chapter: 19
2
Physical Shape of Alternator
3
Rotor and Stator of Alternator
4
Working principle
In case of alternator (AC generator), armature is stationary and the field is rotating. When DC voltage is applied to the field then a constant magnetic flux is produced. At the presence of this constant magnetic flux, rotor is rotated through the prime over. When field (rotor) rotates, armature conductors are cut by the magnetic flux and hence an emf is induced in it. Since, the magnetic poles are alternately N & S, therefore an alternating emf is produced in the stator conductor.
5
Short-Pitch or Fractional-Pitch Winding
In most alternators, opposite conductors of a coil are less than one pole pitch i.e less than spanning over 1800.
This type of winding is known as short-pitch or fractional-pitch winding
B. L. Thereja; Art:37.11; page:1309
6
Advantages & Disadvantages of short-Pitch Winding
Advantages:They save copper of end connectionThey improve the wave-form of generated emf i.e generated emf can be made to approximate to a sine wave more easily and the distorting harmonics can be reduced or totally eliminated.Due to the elimination of high frequency harmonics, eddy current and hysteresis losses are reduced, thereby increasing the efficiency.
7
Disadvantages
The disadvantages of using short-pitch winding is that, the total voltage around the coils is somewhat reduced. Because the voltage induced in two sides of short-pitched coil are slightly out of phase. Therefore, the resultant vector sum is less than their arithmetic sum
B. L. Thereja; Art:37.11; page:1309
8
Pitch FactorQ. What is pitch-factor? Derive the equation of pitch-factor. Ans: The pitch or coil span factor is defined as the ratio of actual coil voltage to the coil voltage for a full-pitch coil.Hence, pitch factor, KP = Vector sum of induced emf per coil/ Arithmetic sum of induced emf per coilLet, Es be the induced emf in each side of the coil.
Now consider the following figures:B. L. Thereja; Art:37.11; page:1309
9
1E 2E sE
sE
sE sE
sE2
If the coils are full-pitch, then the total induced emf in the coil according to Fig-1 is , E1=2ES
If the coil is short-pitched by an angle, then according to Fig-2 the resultant induce emf is
=
= =
Which is always less than 1.
cos2 2222 sss EEEE cos12 2 sE
2cos2.2 2
sE 2cos2
sE
2cos
22
cos2
1
2
s
s
p E
E
E
EK
Fig-1 Fig-2
10
Distributed Winding In each phase of an alternator if the coils are not concentrated or bunched in one slot, but are distributed in a number of slots, then such type of winding is called distributed winding.
Q. What is distributed winding and distribution factor?
B. L. Thereja; Art:37.12; page:1310
11
Distribution or Breadth or Spread or Winding factor
The ratio of actual phase voltage to that which would exist for a concentrated winding is known as distribution factor. It is also known as “Breadth factor” or “Spread factor” or “Winding factor”. It is denoted by Kd
So, distribution factor, Kd = e.m.f with distributed winding / e.m.f with concentrated winding
B. L. Thereja; Art:37.12; page:1311
12
Derivation of Distribution factor
E
Dc
A
B
m
r
sErE
2
Let, be the angular displacement between slots.
= 1800 / No. of slots = 1800 /nLet, m= No. of slots/phase/pole
= phase spread angleIf be the induced emf in one
slot,then total voltage induced in one polar group i.e arithmetic
sum=mNow, from OAM,
o
msE
sE
r
AMSin
2
2
rSinAM
22
rSinE sAMEAB s 2
N
2
m
M
r
B.L.Thereja; Art:37.12; Page:1311-1312; Fig:37.21
13
Derivation of Distribution factor So, arithmetic sum=
Now, from ONE,
So, vector sum,
So, distribution factor, Kd =
When is very small then, So, Kd
r
NEmSin
2
2
mrSinNE
22
mrSinE r
22
22.
rmSinrSinmmE s
NEEAE r 2
22
22
rmSin
mrSin
2
2
mSin
mSin
2
2
m
mSin
22 Sin
14
Equation of induced emf Let,
Z = No. of conductors or coil sides in series/phase
= 2T [ where T= No. of coils or turns per phase] P = No. of poles; N = Rotor Speed in r.p.m F = Frequency of the induced emf in HZ φ = Flux per pole in wb Kd = Distribution Factor
Kc = pitch or span factor
K f = Form factor=1.11
2
2
mSin
mSin
2cos
B. L. Thereja; Art:37.13; page:1313
15
Equation of Induced e.m.fIn one revolution of the rotor each stator conductor is cut by a flux of φp. So, dφ= φp & dt = s. So, average induced
emf per conductor = Again,
average induced emf per conductor =
If there are z conductors in series/phase, then average emf/phase and R.M.S value of emf/phase= volt. If the coils are short-pitched & distributed, then actual induce emf = volt. If the alternator is star-connected then the line voltage is times the phase voltage.
N
60
p
fN
120
fp
fp
dt
d 2
120
60
fTfz 42 fT411.1
TfKK dc 44.4Tf44.4
3
B. L. Thereja; Art:37.13; page:1313
6060NP
N
p
dt
d
16
Effect of Harmonics on Pitch & Distribution Factor
2
3cos
2
5cos
2cos
cK
Pitch Factor
--For Fundamental
--For 3rd Harmonics
--For 5th Harmonics2
32
3
mSin
mSin
2
2
mSin
mSinKd
Distribution Factor
Math: B.L. Thereja; Example:37.8,37.13
--For fundamental
--For 5th Harmonics
--For 3rd Harmonics
252
5
mSin
mSin
B. L. Thereja; Art:37.14; page:1313-1314
17
Alternator Characteristics
E
g
TVLOAd
aR aI
aX
0)( Taaaag VjXIRIE
= Generated Voltage
= Terminal Voltage
= Armature current
= Armature Resistance
= Armature reactance
TV
aR
aX
aI
gE
Rosenblatt Art:19.9, Fig:19.13; page:381
Taaag VjXRIE )(
1818
Effect of Power factor on Generated Voltage
aaXI
TVaaRI
For Lagging power Factor
Rosenblatt Art:19.9, Fig:19.14; page:382
sinTV
cosTV
aI
gE
22 sincos aaTaaTg XIVRIVE
1919
aaXI
aaRI
TVaI
gE
Generated Voltage For Unity Power Factor
Rosenblatt Art:19.9, Fig:19.14; page:382
22aaaaTg XIRIVE
2020
aaXI
aaRI
TV
aI
gE
Generated Voltage For Leading Power Factor
Rosenblatt Art:19.9, Fig:19.14; page:382
Rosenblatt; Math: Example:19.9, 19.10
22 sincos aaTaaTg XIVRIVE
cosTV
sinTV