0702 cold planing presentation
DESCRIPTION
Presentation the cold planing technology in highway constructionTRANSCRIPT
-
Cold Planing Introduction Revolutionized HMA removal, leveling and overlay
preparation Considerable changes over the last 30 years
Definitions Cold Planing
removal of the existing pavement to the desired depth Cold Milling
removal pavement surface using drum-mounted carbide steel cutting bits
Diamond grinding Restore ride Improve friction Not to remove material
Grooving resist hydroplaning
Half Lane Front Loading Planer
A 2 & 12 FT Cutting Drums Typical cold milling equipment
Milling head typically rotates counter to the direction of travel, upcutting the material. Typical speed 6 m/min (20 ft/min) Milling heads as wide as 12 ft - up to 16ft Interchangeable cutting heads Variable widths
-
Cold Milling Equipment Cold Planing Around Manhole
Purpose and Application
Primary use on HMA Overlay Prep 100% Recycling
Full lane to partial lane width Full depth partial depth to removal Reconstruction Emerging use on PCC
Cold Milling Uses?
Removal of rutting Restoration of curb line Restoration of cross slope Restoration of surface friction Mass removal of HMA Roughened surface for improved bond
Trenching With Cold Planer Distresses Treated by CP Raveling Bleeding Shoulder drop off Rutting Corrugations Shoving
-
Limitations and Effectiveness
Milled Surface texture is a function of: Carbide bit spacing and condition Depth of cut Rotational speed of head Speed of travel
General Steps of Cold Planing
Reclaiming and sizing Removal Cleaning of the milled surface. Application of traffic control markings Wearing course.
Design Considerations
Resulting surface profile Skid resistance Pavement removal and surface profiling Maintain bridge clearance and curb reveal
Construction Considerations
Pavement to be resurfaced Standard head with normal carbide bits Standard line and grade requirements
Pavement surface to be turned over to traffic Special heads with more carbide bits Smoothness and grade requirements in line with HMA
wearing course
Full Lane Cold Planer Construction Considerations
How will grade be controlled? Ski, string line, laser, other
Will ride quality be measured on the milled surface? Profilograph, profiler, none
-
Typical Surface Resulting from Cold MillingPoor Milled Surface
Special Multiple Wrap DrumMicro milling or carbide grinding
Standard Fine Drum Drum
Fine Textured Surface
Quest
ions?