( page ) · Çevre ùartlari (environmental conditions) bu sertifika laboratuvarın yazılı izni...
TRANSCRIPT
+90 312 267 32 43 AB-0045-T
www.eldas.com.tr LVD19-0077/R1
[email protected] 04-19
02 / 09
Bu sertifika laboratuvarın yazılı izni olmadan kısmen kopyalanıp çoğaltılamaz.İmzasız ve mühürsüz sertifikalar geçersizdir.
This certificate shall not be produced other in full expect with the permission of the laboratory . Certificate without signature and seal are not valid.
This is a LVD test report. The test results presented in this report relate only to the object/system tested.
The results contained in this report reflect the results for this particular model and serial number. It is the
responsibility of the manufacturer/applicant to ensure that all production models meet the intent of the
requirements detailed within this report.
SONUÇ / CONCLUSION Bu bir LVD test raporudur.
Bu raporda verilen sonuçlar ve değerlendirmeler sadece üretici/başvuru sahibi tarafından test için
sağlanan ürün/sistem ile ilgilidir. Üretilen diğer bütün modellerin bu raporda verilen gereksinimleri
karşılaması üreticinin/başvuru sahibinin sorumluluğundadır.
Akreditasyon No:
Rapor No:
Deney Tarihi:
Sayfa / Page:
10.05.2019
DOKÜMAN TARİHÇESİ / REVISION HISTORY
Baskı / Edition Tarih / Date
İkinci yayın / Second edition 27.06.2019
Açıklama / Remarks
İlk yayın / First Edition -----
Revised the standard description on the first page.
İlk sayfadaki standart açıklaması düzenlendi.
FT-01 / Rev.03 / 01.02.2017
+90 312 267 32 43 Akreditasyon No: AB-0045-T
www.eldas.com.tr Rapor No: LVD19-0077/R1
[email protected] Deney Tarihi: 04-19
Sayfa / Page: 03 / 09
1 - DÖKÜMANTASYON SAYFA
(Documantation ) ( Page )
1.1 DGC, Çevre Koşulları ve Sembollerin Tanımları 4
(Conditions/Power Utilized,Description of the EUT & Symbol Definitions)
1.2 Deney Standardları 5
(Test Standards)
1.3 Deney Sonuçları 6
(Test Results)
2 Deney Sonuçları ve Koşulları
(Test Results and Conditions)
2.1 IP6X Toza Karşı Koruma 7
(IP6X Dust Protection Test)
2.2 IPX7 Suya Karşı Koruma 8
(IPX7 Water Protection Test)
3 Ekler
(Attachments)
3.1 DGC'nin Fotoğrafları 9
(Photos of EuT)
This certificate shall not be produced other in full expect with the permission of the laboratory . Certificate without signature and seal are not valid.
İÇİNDEKİLER
( Contents )
Bu sertifika laboratuvarın yazılı izni olmadan kısmen kopyalanıp çoğaltılamaz.İmzasız ve mühürsüz sertifikalar geçersizdir.
FT-01 / Rev.03 / 01.02.2017
+90 312 267 32 43 Akreditasyon No: AB-0045-T
www.eldas.com.tr Rapor No: LVD19-0077/R1
[email protected] Deney Tarihi: 04-19
Sayfa / Page: 04 / 09
DENEYDEN GEÇİRİLEN CİHAZIN :
(Equipment Under Test's)
Markası: Beyan Gerilimi:
(Brand) (Rated Voltage)
Modeli: Beyan Gücü:
(Model) (Rated Current/Power)
Seri No:
(SN)
Kısa Tanımı:
(Short Description)
Deneyler sırasında ölçülen çevre şartları ilgili sayfalarda belirtilmiştir.
(The enviromental conditions are measured during tests, are determined related pages.)
DENEY RAPORUNDA KULLANILAN SEMBOLLERİN TANIMLARI
( Definations of Symbols Used in This Test Report )
DGC - Deneyden geçen cihaz
(EUT-Equipment under test)"
■ - Siyah kutu, deney raporunda kullanılan cihaz, standard ve koşulları gösterir.
(The black square indicates that the listed condition, standard or equipment is applicable for this report.)
□ - Boş kutu, deney raporunda kullanılmayan cihaz, standard ve koşulları gösterir.
(The empty square indicates that the listed condition, standard or equipment is not applicable for this report.)
ÇEVRE ŞARTLARI
(Environmental Conditions)
Bu sertifika laboratuvarın yazılı izni olmadan kısmen kopyalanıp çoğaltılamaz.İmzasız ve mühürsüz sertifikalar geçersizdir.
DAYGAS
PROTOTİP
2000 wDE 2000
ELEKTRİKLİ KIZILÖTESİ ISITICI
ELECTRIC INFRARED HEATER
230 v
This certificate shall not be produced other in full expect with the permission of the laboratory . Certificate without signature and seal are not valid.
FT-01 / Rev.03 / 01.02.2017
+90 312 267 32 43 Akreditasyon No: AB-0045-T
www.eldas.com.tr Rapor No: LVD19-0077/R1
[email protected] Deney Tarihi: 04-19
Sayfa / Page: 05 / 09
■ TS EN 60529:1991/AC:1993 :2011
■ TS 3033 EN 60529/T1 :1997
■ EN 60529:1991
■ EN 60529:1991/A1:2000
■ EN 60529:1991/AC:1993
■ TS 3033 EN 60529/T2 :2004
DENEY STANDARDLARI
Bu sertifika laboratuvarın yazılı izni olmadan kısmen kopyalanıp çoğaltılamaz.İmzasız ve mühürsüz sertifikalar geçersizdir.
This certificate shall not be produced other in full expect with the permission of the laboratory . Certificate without signature and seal are not valid.
(TEST STANDARDS)
Deneyler aşağıdaki standardlara göre yapılmıştır:
(The tests were performed according to following standards)
■ TS 3033 EN 60529 :1997
■ TS 3033 EN 60529/A1 :2005
FT-01 / Rev.03 / 01.02.2017
+90 312 267 32 43 Akreditasyon No: AB-0045-T
www.eldas.com.tr Rapor No: LVD19-0077/R1
[email protected] Deney Tarihi: 04-19
Sayfa / Page: 07 / 09
Test sonrası DGC muhafazasında toz birikimi gözlenmesine rağmen filament ve elektrikli kısım
içerisinde toz birikmesi gözlenmemiştir.
(Although dust accumulation was observed in the EUT enclosure after the test, dust accumulation in the
filament and electrical part was not observed.)
IP 6X Toza Karşı Koruma Deneyi
IP 6X Dust Protection Test
Deney Talimat No: DT-LVD-25 İlgili standard : Sayfa 5'e bakınız
(Test Method No) (Related Standard) : See page 5
Çevre Koşulları : 23,5 °C %38,2 RH Tarih : 08.04.2019
(Environmental Conditions) (Date)
TEST ŞARTLARI VE SONUÇLARI
(TEST CONDITIONS AND RESULTS)
Testin tanımı: Deney, kapalı bir deney hücresinde talk pudrasını askıda tutan uygun bir
düzenle, toz sirkülasyon pompasının değiştirilebildiği ana prensiplerle birleşik
durumda olan bir toz hücresi kullanılarak yapılır.
Deneyden geçirilen mahfaza, ancak bir vakum pompasına bağlanmadan,
normal çalışma konumunda deney hücresi içine yerleştirilir. Normal olarak açık
olan herhangi bir boşaltma deliği deney süresinde açık bırakılmalıdır. Deneye 8
saat süre boyunca devam edilmelidir.
(Test specification)
Bu sertifika laboratuvarın yazılı izni olmadan kısmen kopyalanıp çoğaltılamaz.İmzasız ve mühürsüz sertifikalar geçersizdir.
This certificate shall not be produced other in full expect with the permission of the laboratory . Certificate without signature and seal are not valid.
(The test is made using a dust chamber incorporating the basic principles
whereby the powder circulation pump may be replaced by other means suitable to
maintain the talcum powder in suspension in a closed test Chamber.
The enclosure under test is supported in its normal operating position inside the test
chamber, but is not connected to a vacuum pump. Any drain-hole normally open
shall be left open for the duration of the test. The test shall be continued for a period
of 8 h.)
Test süresi: 8 Saat
(Test Duration) (Test Duration)
FT-01 / Rev.03 / 01.02.2017
+90 312 267 32 43 Akreditasyon No: AB-0045-T
www.eldas.com.tr Rapor No: LVD19-0077/R1
[email protected] Deney Tarihi: 04-19
Sayfa / Page: 08 / 09
Test sonrası DGC muhafazasında su birikimi gözlenmesine rağmen filament ve elektrikli kısım
içerisinde su birikmesi gözlenmemiştir.
(Although water accumulation was observed in the EUT enclosure after the test, water accumulation in the
filament and electrical part was not observed.)
30 dakika
Test Specification 30 minutes
1100 mm Mahfazanın en alt noktası su yüzeyinden 1100 mm
aşağıda olaca şekilde konumlandırılmıştır.
IP X7 Suya Karşı Koruma DeneyiIP X7 Water Ingress Protection Test
Deney Talimat No :
(Test Method No)
Çevre Koşulları :
TEST ŞARTLARI VE SONUÇLARI(TEST CONDITIONS AND RESULTS)
(Environmental Conditions)
Sayfa 5'e bakınız
(Date)
İlgili standard :
This certificate shall not be produced other in full expect with the permission of the laboratory . Certificate without signature and seal are not valid.
Testin tanımı:
(Test specification)
Test Süresi
Lowest point of enclosure is located 1100 mm below the
surface of the water.
EUT < 850 mm
23,5 °C , %38,2 RH
(Related Standard)
Bu sertifika laboratuvarın yazılı izni olmadan kısmen kopyalanıp çoğaltılamaz.İmzasız ve mühürsüz sertifikalar geçersizdir.
See page 5
09.04.2019
DT-LVD-21/R2
:
Tarih :
(The test is made by completely immersing the enclosure in water in its service position as specified by the
manufacturer so that the following conditions are satisfied:
a) the lowest point of enclosures with a height less than 850 mm is located 1 000 mm below the surface of the
water;
b) the highest point of enclosures with a height equal to or greater than 850 mm is located150 mm below the
surface of the water;
c) the duration of the test is 30 min;
d) the water temperature does not differ from that of the equipment by more than 5 K.)
Deney aşağıdaki şartlar sağlanacak biçimde mahfaza, imalatçıtarafından belirtilen çalışma konumunda
suya bütünüyle daldırılarak yapılır:
a) Yüksekliği 850 mm’den az olan mahfazaların en alt noktası su yüzeyinden 1000 mm aşağıda
bulundurulur;
b) Yüksekliği 850 mm’ye eşit veya daha büyük mahfazaların en yüksek noktasısu yüzeyinden 150
mm aşağıda bulundurulur;
c) Deney süresi 30 dakikadır;
d) Su sıcaklığıile donanımın sıcaklığının farkı5 K’dan daha fazla olmamalıdır.
FT-01 / Rev.03 / 01.02.2017
+90 312 267 32 43 Akreditasyon No: AB-0045-T
www.eldas.com.tr Rapor No: LVD19-0077/R1
[email protected] Deney Tarihi: 04-19
Sayfa / Page: 09 / 09
DGC'nin Fotoğrafları
(Photos of EUT)
Bu sertifika laboratuvarın yazılı izni olmadan kısmen kopyalanıp çoğaltılamaz.İmzasız ve mühürsüz sertifikalar geçersizdir.
This certificate shall not be produced other in full expect with the permission of the laboratory . Certificate without signature and seal are not valid.
FT-01 / Rev.03 / 01.02.2017