windshield wiper motor removal and installation

Upload: michael-hernandez

Post on 08-Mar-2016

24 views

Category:

Documents


0 download

TRANSCRIPT

  • 2002 Ford EXPLORER SPORT TRAC Submodel: | Engine Type: V6 | Liters: 4.0Fuel Delivery: FI | Fuel: GAS

    SECTION 501-16: Wipers and Washers 2002 Explorer Sport/Sport Trac Workshop ManualREMOVAL AND INSTALLATION Procedure revision date: 01/17/2002

    Windshield Wiper Motor

    Removal

    1. Disconnect the washer hose from the LH washer jet nozzle.

    2. Remove the cowl grilles; for additional information, refer to Section 501-02.

    3. Unsnap the wiper motor clip from the RH wiper mounting arm and pivot shaft.

    4. Disconnect the RH wiper mounting arm and pivot shaft from the LH wiper mounting arm and pivot shaft and move both away from the windshield wiper motor.

    5. Disconnect the electrical connector.

    6. Remove the ground strap nut and position the strap aside.

    7. CAUTION: The internal permanent magnets used in the windshield wiper motor are made of a glass-like material. To avoid damaging the magnets, do notstrike the motor with a hammer or any other object.

  • Remove the windshield wiper motor.

    Remove the stud bolts.

    Remove the bolts.

    Installation

    1. CAUTION: The internal permanent magnets used in the windshield wiper motor are made of a glass-like material. To avoid damaging the magnets, do notstrike the motor with a hammer or any other object.

    Install the windshield wiper motor.

    1. Install the windshield wiper motor.

    2. Install the stud bolts.

    3. Install the bolts.

    2. Install the ground strap and nut.

    3. Connect the electrical connector.

    4. Install the wiper mounting arm and pivot shaft arms to the windshield wiper motor.

    1. Install the LH wiper mounting arm and pivot shaft onto the windshield wiper motor crank pin.

    2. Install the RH wiper mounting arm and pivot shaft onto the wiper motor crank pin.

    3. Push the retaining clip until it snaps into place.

    5. Install the cowl grilles. For additional information, refer to Section 501-02.

  • 6. Connect the washer hose to the LH washer jet nozzle.

    7. Install the LH wiper pivot arm. Refer to Wiper Pivot ArmFront in this section.

    8. Adjust the LH wiper pivot arm. Refer to Windshield Wiper Blade and Pivot Arm Adjustment in this section.