ROCAVICTORIA WALL BASIN 520 WITH SEMI PEDESTAL

FEATURESRecommended Use Domestic, hotel or commercial

Weight Basin - 13.4kg / Semi Pedestal - 9.0kg

Fixing Wall-mounted

Pedestal Full pedestal and semi-pedestal available as options

CLEANING RECOMMENDATIONSSoapy water or approved bathroom cleaners. This bathroom product should not be cleaned with abrasive materials. Damage caused by any improper treatment is not covered by the product warranty. Refer to Warranty Page for full Terms and Conditions.

To see the complete Roca range go to www.reece.com.au/bathrooms

SPECIFICATIONFixing Requirements Wall basin fixing bolts supplied

Integral Overflow Yes

Tap Hole Availability 1 or 3 tapholes

Plug & Waste Suits 32 x 40mm overflow waste

Water Capacity 5 litres

Colour Availability White

A B C D E650 510 520 335 205560 460 450 295 205520 410 415 255 190

520280

850345

200

415295

475345

850

410255

Dimensions are nominal only

page 1 of 3

Disclaimer: Products in this specification manual must by regulation be installed by licensed and registered trade people. The manufacturer/distributor reserves the right to vary specifications or delete models from their range without prior notification. Dimensions and set-outs listed are correct at time of publication however the manufacturer/distributor takes no responsibility for printing errors.

Tech Page Version 1

ROCAVICTORIA WALL BASIN 520 WITH SEMI PEDESTAL

Basin

Locknut

Bolt

Nylon

Wall

Noggin

Section throughbasin using wallfixing bolts

*Basin can be installedindependantly of pedestalif desired.

Bush / Washer(fig 1)

INSTALLATION INSTRUCTIONSNote: All measurements are taken from finished wall and floor. If basin is installed at different height to that recommended,all other measurements must be adjusted accordingly. If fixing to timber framed walls or partitioning, the wall should be reinforced with noggins to receive fixing bolts/screws for both the basin and the semi-ped.

• Drill holes into walls at recommended height and fixing centres and install fixing bolts supplied (fig 1).• Fit selected tapware to basin. Fit the supplied overflow waste to basin ensuring it is sealed with silicone on top.

• Carefully align basin complete with fittings onto protruding bolts.

• Insert nylon bushes and locking nut and partially tighten lock nuts to hold basin into position. Make minor adjustments at thisstage to ensure basin is level and then fully tighten lock nuts. Do not over tighten.

• If desired all visible external edges can be joint sealed using flexible sealant ensuring to wipe off any excess.

• For fitting of semi-ped under basin, please refer to pictorial steps 3 to 8. Make minor adjustments to basin height if requiredbefore finally tightening basin locking nuts.

VICTORIAA336312..R

1 2

850-XX

1 2

850

Ø12 17

page 2 of 3

Plumbers, please ensure a copy of the installation instructions is left with the end user for future reference

INSTALLATION

ROCAVICTORIA WALL BASIN 520 WITH SEMI PEDESTAL

A39

2501

120a

3 4

5 6

87

Ø10

10

1

17

1

2

x2

2

Roca Sanitario, S.A.Avda. Diagonal, 51308029 Barcelona -SPAINTeléfono 93 366 1200Fax 93 419 4501www.roca.es

page 3 of 3

Plumbers, please ensure a copy of the installation instructions is left with the end user for future reference

INSTALLATION