I n s t r u c t i o n s f o r u s e

Whenever handling parts, please exercise caution and ensure that your ROOR Vapor is set up in a suitable location.

The conical glass connections are joined with an accurate fit. To dismantle, first loosen these connections by turning before separating the parts.

Fill the ROOR Vapor body with a little water (until just above the holes) . The water filters all solids out of the vapour while also cooling it.

Place head with stainless steel screen on body. Put the leaves, finely ground with a mill, into the head until the screen is fully covered. Now place the heating element on the filled head. Connect the heating element to the power adapter and power plug with the socket.

Assembly

Scope of supply for electronics -ROOR VAPOR basic (constant)

Scope of supply for electronics -ROOR VAPOR XL (controllable)

Scope of supply for glass

Switching power adapter Temperature adjustment controller

Scope of supply for electronics

(US)

(EU)Power plugHeating element/injector Power adapter

Bowl with stainless steel screen ROOR Vapor pokerROOR Vapor cooling stand

ROOR Vapor body ROOR Vapor mouthpiece

To learn more visit w w w.roor.de/vapor or contact vapor@roor.de

(US)

(EU)

User instructionsCaution: To avoid damaging the heating element, NEVER BLOW into the ROOR Vapor.

As soon as a sufficient temperature is reached, the ROOR Vapor can be left on for several hours and used without preheating.

2) TIPP! You should inhale slowly and continuously for optimum efficiency

3) After inhaling several times, remove the heating element and place on the stand.(Take care, it will be very hot)Avoid other materials as these could be highly flammable or heat-sensitive. Alternatively, the heating element itself may be damaged.Then use the glass rod to stir the leaves to ensure complete vaporisation.

4) The vaporisation process is complete when the green of the leaves turns yellow or the taste becomes unpleasant.

5) To replace the leaves, follow the instructions under point 3.

6) Empty the bowl after every session. This is easier to do when it is still warm. The screen is very easy to remove along with the glass rod. To prevent blockages, clean the bowl regularly with a small brush.

Thanks for purchasing the ROOR Vapor. We hope you enjoy using our product.

Allow 10 minutes for warming up before use.

1) Set the temperature adjustment controller to the required temperature. The optimum temperature for resinous leaves is about 190°C/375°F on the regulation display.

Abstufungen/Temperaturen (*only XL-Version)

1 - 90°C/194°F 2 - 110°C/230°F 3 - 130°C/266°F

4 - 150°C/300°F 5- 180°C/356°F 6 - 190°C/375°F

7 - 200°C/392°F 8 - 210°C/410°F 9 - 220°C/428°F

10- 230°C/446°F

1) Switch on the ROOR Vapor with the switching power adapter.

ROOR VAPOR basic ROOR VAPOR XL

Connect the heating element to the power adapter and power plug with the socket.

WARNINGWith the XL model, the controller MUST be placed between the power adapter and heating element.NEVER connect without controller otherwise too much power will enter the heating element and the device may be damaged.

Switching power adapter

TemperatureadjustmentcontrollerHeating element Heating element Power plug

(US)

(EU)Power plug